HP MSR1000 Router manual Appendix B LEDs, Panel LEDs, LED description, State Description

Page 38

Appendix B LEDs

Panel LEDs

	Figure 35 MSR1002-4 LEDs
	4
	3	5 6	5	6
	2	5 6	5	6
	2
	1

(1) Asynchronous/synchronous	(2) SFP port LED (SFP5)	(3) Power supply LED (PWR)
serial interface LED (SERIAL0)

(4) System status LED (SYS)	(5) 10/100 Mbps link LED for the
	Gigabit Ethernet port

(6)1000 Mbps link LED for the Gigabit Ethernet port

Figure 36 MSR1003-8 LEDs

(1) System LED (SYS)

(2) Power supply LED (PWR)

(3) Gigabit Ethernet port LED (GE0 to GE9)

LED description

LED

SYS

PWR

	State	Description
	Flashing green (1 Hz)	Comware has started with the configuration file and
	Flashing green (1 Hz)	the router has booted up.
		the router has booted up.

	Flashing green (8 Hz)	The BootWare runs.

	Steady green	The SDRAM is performing self-test.

	Flashing yellow (1 Hz)	The DDR3 SDRAM has failed the self-test.

	Flashing yellow (8 Hz)	The extended segment does not exist.

	Steady yellow	The boot image does not exist.

	Off	No power input, or exceptions have occurred.
	Steady green	The power supply is operating correctly.

34

Image 38

Contents HP MSR1000 Routers Page Contents Page Safety symbols Preparing for installationSafety recommendations General safety recommendationsCleanness Examining the installation siteTemperature and humidity Cooling system ESD preventionLightning protection Rack-mountingRequirements Result Installation accessoriesInstallation checklist Components when observing or moving a removed Requirements Result Installation flowchart Installing the routerInstallation prerequisites Installation flow Mounting the router on a workbench Installing the routerInstalling the router in a rack Marking the positions of cage nuts Page Grounding the router Grounding the router through the rackGrounding the router through the rack Grounding the router with a grounding strip Installing an interface module Installing a SICInstalling a Dsic Removing the filler panelConnecting interface cables Fasten the captive screws to secure the DsicLogging in through the console port Connecting a console cableAttaching a USB device Setting terminal parameters Connection descriptionSetting the serial port used by the HyperTerminal connection HyperTerminal window Powering on the router Connecting an AC power cordVerifying the installation Verifying before power-onPowering on the router Displaying boot informationYou can now configure the router Configuring basic settings for the routerExamining the router after power-on Press Enter, and the following prompt appearsReplacing a Dsic Replacement procedureReplacing a SIC Removing a Dsic System configuration problems TroubleshootingPower supply failure No terminal displayNo response from the serial port Restoring the factory settingsGarbled terminal display ScenarioReset button usage guidelines MSR1002-4 Appendix a Chassis views and technical specificationsChassis views Following figures are for illustration onlyMSR1002-4 MSR1003-8 Technical specificationsMSR1003-8 MSR1002-4 MSR1003-8 LED description Appendix B LEDsPanel LEDs State DescriptionSERIAL0 Appendix C Slot arrangement Related information Support and other resourcesContacting HP Conventions Convention DescriptionNetwork topology icons Index E G I L M N P R S T V W

Related manuals

Manual 8 pages 47.39 Kb