HP Broadband Service Analyzer manual To Set Up the Interface Pod

Page 10

To Set Up the Interface Pod

To Set Up the Interface Pod

Caution	Handle the interface pod with care to avoid electrostatic discharge (ESD)
	damage during unpacking, installation, and operation. The connectors on
	the front and rear of the interface pod are susceptible to ESD.
	1	Insert the interface pod into the analyzer.
		See “To Insert the Interface Pod” on page 7. The procedure is the same for
		all interface pods.
	2	Connect the interface pod to the system under test.
		See “To Connect to the System Under Test” on page 8. The analyzer
		automatically recognizes and conﬁgures the interface pod.
	3	If you want to change any of the conﬁguration parameters, see “To
		Manually Conﬁgure the Interface Pod” on page 11.

6

Image 10

Contents Setting Up 25.6 Mb/s Interface Pod Broadband Service AnalyzerPrinting history WarrantyCopyright Product supportContents What is it? What does it do? About the 25.6 Mb/s Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal ConcentratorFront Panel at a Glance Cable and Line Connector Details Cable and Line Connector DetailsPin Signal Connector Cable ConﬁgurationsConnector Interface Pod User DeviceTo Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Remove the Interface Pod To Connect to the System Under TestTo Set Up the Interface Pod Automatic Conﬁguration Parameters See alsoClick to set the configuration To Manually Conﬁgure the Interface PodWhat to Do Next X8 Timing Marker Source SettingFill Cell Filter Setting What to Do NextCommunications Standards Standards and SpeciﬁcationsPhysical Speciﬁcations Humidity Environmental SpeciﬁcationsParameter Nominal Min Max AltitudeExclusive Remedies Certification WarrantyLimitation of Warranty Restricted Rights LegendDo not clean with fluids Safety SymbolsSymboles des sécurité Service et ajustementService non autorisé AvertissementDeclaration of Conformity