HP Broadband Service Analyzer manual To Set Up the Interface Pod

Page 13

To Set Up the Interface Pod

Some common system and test connections are

∙an intrusive system connection—network element

∙remote loopback

∙in-line test connections

See the HP E5200A Broadband Service Analyzer User’s Guide or the Online Help for details about these system connections.

The analyzer automatically sets the interface pod transmit and receive parameters and conﬁgures according to the signal it receives from the interface pod. See “Automatic Conﬁguration Parameters” on page 10 for more details.

If you remove the interface pod and replace it with another while you are logged in to the analyzer, the screen displays the message

Auto configuring, please wait...

Automatically configuring physical interfaces and protocols according to the monitored signal.

Note The UNI Signaling Test Application does not display a message while it performs auto- configuration.

9

Image 13

Contents Broadband Service Analyzer Setting Up 25.6 Mb/s Interface PodCopyright WarrantyPrinting history Product supportContents What is it? What does it do? About the 25.6 Mb/s Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal ConcentratorFront Panel at a Glance Cable and Line Connector Details Cable and Line Connector DetailsConnector Connector Cable ConﬁgurationsPin Signal Interface Pod User DeviceTo Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Connect to the System Under Test To Remove the Interface PodTo Set Up the Interface Pod See also Automatic Conﬁguration ParametersTo Manually Conﬁgure the Interface Pod Click to set the configurationFill Cell Filter Setting X8 Timing Marker Source SettingWhat to Do Next What to Do NextCommunications Standards Standards and SpeciﬁcationsPhysical Speciﬁcations Parameter Nominal Min Max Environmental SpeciﬁcationsHumidity AltitudeLimitation of Warranty Certification WarrantyExclusive Remedies Restricted Rights LegendSafety Symbols Do not clean with fluidsService non autorisé Service et ajustementSymboles des sécurité AvertissementDeclaration of Conformity