HP Broadband Service Analyzer manual What to Do Next, X8 Timing Marker Source Setting

Page 16

What to Do Next

X8 Timing Marker Source Setting

When you change the X8 timing marker source setting, the trafﬁc generator settings are cleared. The analyzer does this because it has to re- calculate and re-adjust the total allowable transmit bandwidth to

∙allow for the X8 marker when you enable X8 marker generation

∙allocate all available bandwidth to transmit trafﬁc when you disable X8 marker generation

Fill Cell Filter Setting

This setting allows you to specify that the analyzer generates idle or unassigned cells to ﬁll unused bandwidth. When this option is disabled, unused bandwidth is handled at the physical line level by the transmit drivers.

What to Do Next

The interface pod is now ready for use.

See the Online Help to ﬁnd out the different tasks you can perform using the analyzer and interface pod.

12

Image 16

Contents Setting Up 25.6 Mb/s Interface Pod Broadband Service AnalyzerWarranty CopyrightPrinting history Product supportContents What is it? What does it do? About the 25.6 Mb/s Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal ConcentratorFront Panel at a Glance Cable and Line Connector Details Cable and Line Connector DetailsConnector Cable Conﬁgurations ConnectorPin Signal Interface Pod User DeviceTo Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Remove the Interface Pod To Connect to the System Under TestTo Set Up the Interface Pod Automatic Conﬁguration Parameters See alsoClick to set the configuration To Manually Conﬁgure the Interface PodX8 Timing Marker Source Setting Fill Cell Filter SettingWhat to Do Next What to Do NextCommunications Standards Standards and SpeciﬁcationsPhysical Speciﬁcations Environmental Speciﬁcations Parameter Nominal Min MaxHumidity AltitudeCertification Warranty Limitation of WarrantyExclusive Remedies Restricted Rights LegendDo not clean with fluids Safety SymbolsService et ajustement Service non autoriséSymboles des sécurité AvertissementDeclaration of Conformity