HP Broadband Service Analyzer manual Cable and Line Connector Details

Page 8

Cable and Line Connector Details

Cable and Line Connector Details

The HP E5129A 25.6 Mb/s Interface Pod’s connector pin conﬁguration adheres to the speciﬁcation deﬁned in the IBM Corporation’s ATM 25.6 Mb/s PHY Compatibility Speciﬁcation, Version 2.0, 15 October, 1993.

Note In order to comply with EMC regulations, you must use one of the three connection cables that are supplied with the interface pod to connect to the system under test. See Connector Cable Configurations on the next page for details.

4

Image 8

Contents Setting Up 25.6 Mb/s Interface Pod Broadband Service AnalyzerWarranty CopyrightPrinting history Product supportContents What is it? What does it do? About the 25.6 Mb/s Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal ConcentratorFront Panel at a Glance Cable and Line Connector Details Cable and Line Connector DetailsConnector Cable Conﬁgurations ConnectorPin Signal Interface Pod User DeviceTo Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Remove the Interface Pod To Connect to the System Under TestTo Set Up the Interface Pod Automatic Conﬁguration Parameters See alsoClick to set the configuration To Manually Conﬁgure the Interface PodX8 Timing Marker Source Setting Fill Cell Filter SettingWhat to Do Next What to Do NextPhysical Speciﬁcations Standards and SpeciﬁcationsCommunications Standards Environmental Speciﬁcations Parameter Nominal Min MaxHumidity AltitudeCertification Warranty Limitation of WarrantyExclusive Remedies Restricted Rights LegendDo not clean with fluids Safety SymbolsService et ajustement Service non autoriséSymboles des sécurité AvertissementDeclaration of Conformity