HP Broadband Service Analyzer manual Connector Cable Conﬁgurations, Interface Pod User Device

Page 9

Cable and Line Connector Details

Connector Cable Conﬁgurations

The interface pod comes with three cables:

∙part number E1619-64300 connects a user device to the network (2 to 3 in the table below)

∙part number E1619-64301 connects the interface pod to a user device (1 to 2 in the table below)

∙part number E1619-64302 connects the interface pod to the network equipment (1 to 3 in the table below)

The following table sets out the pin conﬁgurations for the three connector types:

Pin 8

Pin 1

1. Interface Pod		2. User Device		3. Network Equipment
Connector		Connector		Connector
Pin	Signal	Pin	Signal	Pin	Signal

1		1	TxA	1	RxA
2		2	TxB	2	RxB
3	RxA	3		3
4	TxA	4		4
5	TxB	5		5
6	RxB	6		6
7		7	RxA	7	TxA
8		8	RxB	8	TxB

5

Image 9

Contents Broadband Service Analyzer Setting Up 25.6 Mb/s Interface PodCopyright WarrantyPrinting history Product supportContents What is it? What does it do? About the 25.6 Mb/s Interface Pod To Access User Online Help Online HelpOnline Help Access Signal Concentrator Front Panel at a GlanceFront Panel at a Glance Cable and Line Connector Details Cable and Line Connector DetailsConnector Connector Cable ConﬁgurationsPin Signal Interface Pod User DeviceTo Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Connect to the System Under Test To Remove the Interface PodTo Set Up the Interface Pod See also Automatic Conﬁguration ParametersTo Manually Conﬁgure the Interface Pod Click to set the configurationFill Cell Filter Setting X8 Timing Marker Source SettingWhat to Do Next What to Do NextStandards and Speciﬁcations Communications StandardsPhysical Speciﬁcations Parameter Nominal Min Max Environmental SpeciﬁcationsHumidity AltitudeLimitation of Warranty Certification WarrantyExclusive Remedies Restricted Rights LegendSafety Symbols Do not clean with fluidsService non autorisé Service et ajustementSymboles des sécurité AvertissementDeclaration of Conformity