HP Broadband Service Analyzer manual What is it? What does it do?

Page 4

Guide to the HP E5200A Broadband Service Analyzer Documentation

Guide to the HP E5200A Broadband Service

Analyzer Documentation

The HP E5200A Broadband Service Analyzer comes with a comprehensive set of paper and online documentation. Use the following table to determine which documents you should use.

What is it?

What does it do?

Who is it for?

User’s Guide

contains instructions on how to set

all users

 

up and install the analyzer

 

 

provides an outline of the most

 

 

common functions

 

 

provides an outline of the most

 

 

common system administration

 

 

functions

 

 

lists electrical, mechanical, and

 

 

environmental specifications

 

Application

contains information on installing and

all users

Guide

starting the application, along with an

 

 

overview of the application.

 

Online Help

four volumes–User, Macro, UPE

all users

 

Compatibility, and Test help–contain

 

 

information about, and instructions

 

 

for using, the analyzer

 

Quick Reference

provides a quick overview of the

 

analyzer's main features and functions

Setting Up the

a series of guides that provide

Interface Pod

descriptions of, and instructions for

guides

installing, individual interface pods

Worldwide

provides information about support,

Support card

service, and warranty

Release Notice

provides information not available

 

when this guide was printed

all users

all users will refer to at least one of these guides

all users

all users

iv

Image 4
Contents Setting Up 25.6 Mb/s Interface Pod Broadband Service AnalyzerWarranty CopyrightPrinting history Product supportContents What is it? What does it do? About the 25.6 Mb/s Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal ConcentratorFront Panel at a Glance Cable and Line Connector Details Cable and Line Connector DetailsConnector Cable Configurations ConnectorPin Signal Interface Pod User DeviceTo Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Remove the Interface Pod To Connect to the System Under TestTo Set Up the Interface Pod Automatic Configuration Parameters See alsoClick to set the configuration To Manually Configure the Interface PodX8 Timing Marker Source Setting Fill Cell Filter SettingWhat to Do Next What to Do NextCommunications Standards Standards and SpecificationsPhysical Specifications Environmental Specifications Parameter Nominal Min MaxHumidity AltitudeCertification Warranty Limitation of WarrantyExclusive Remedies Restricted Rights LegendDo not clean with fluids Safety SymbolsService et ajustement Service non autoriséSymboles des sécurité AvertissementDeclaration of Conformity