HP Broadband Service Analyzer manual Automatic Conﬁguration Parameters, See also

Page 14

To Set Up the Interface Pod

	Automatic Conﬁguration Parameters
	After you insert the interface pod and connect it to the SUT, the analyzer
	automatically conﬁgures to the 25.6 Mb/s electrical signal.
	The analyzer sets the remaining physical layer receive and transmit
	parameters to the following defaults:
	∙ reference (internal) clock
	∙ full duplex, transmit and receive
	∙ ﬁll cell ﬁlter DISABLED
	∙ X8 marker generation OFF
See also	The Online Help contains information about the ATM and signaling layer
	automatic conﬁguration parameters.

10

Image 14

Contents Setting Up 25.6 Mb/s Interface Pod Broadband Service AnalyzerPrinting history WarrantyCopyright Product supportContents What is it? What does it do? About the 25.6 Mb/s Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal ConcentratorFront Panel at a Glance Cable and Line Connector Details Cable and Line Connector DetailsPin Signal Connector Cable ConﬁgurationsConnector Interface Pod User DeviceTo Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Remove the Interface Pod To Connect to the System Under TestTo Set Up the Interface Pod Automatic Conﬁguration Parameters See alsoClick to set the configuration To Manually Conﬁgure the Interface PodWhat to Do Next X8 Timing Marker Source SettingFill Cell Filter Setting What to Do NextPhysical Speciﬁcations Standards and SpeciﬁcationsCommunications Standards Humidity Environmental SpeciﬁcationsParameter Nominal Min Max AltitudeExclusive Remedies Certification WarrantyLimitation of Warranty Restricted Rights LegendDo not clean with fluids Safety SymbolsSymboles des sécurité Service et ajustementService non autorisé AvertissementDeclaration of Conformity