HP Broadband Service Analyzer manual To Manually Conﬁgure the Interface Pod

Page 15

To Set Up the Interface Pod

To Manually Conﬁgure the Interface Pod

1From the Configure menu, select the appropriate port; then select Set Up.

2Click the ATM25 tab.

3Select the parameters you require.

4 Click to set the configuration

or

Click Auto to set the parameters to the default settings. A message warns you that the reconfiguration will cause some measurements and data to be lost and asks if you want to continue. Click OK.

∙Note See the UNI Signaling Test Application’s Help for information on conﬁguring the 25.6 Mb/s interface pod from the B-ISDN UNI Signaling Test Application.

When the conﬁguration is complete, the analyzer updates all relevant screens and windows to reﬂect the new conﬁguration parameters.

11

Image 15

Contents Broadband Service Analyzer Setting Up 25.6 Mb/s Interface PodProduct support WarrantyCopyright Printing historyContents What is it? What does it do? About the 25.6 Mb/s Interface Pod To Access User Online Help Online HelpOnline Help Access Signal Concentrator Front Panel at a GlanceFront Panel at a Glance Cable and Line Connector Details Cable and Line Connector DetailsInterface Pod User Device Connector Cable ConﬁgurationsConnector Pin SignalTo Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Connect to the System Under Test To Remove the Interface PodTo Set Up the Interface Pod See also Automatic Conﬁguration ParametersTo Manually Conﬁgure the Interface Pod Click to set the configurationWhat to Do Next X8 Timing Marker Source SettingFill Cell Filter Setting What to Do NextStandards and Speciﬁcations Communications StandardsPhysical Speciﬁcations Altitude Environmental SpeciﬁcationsParameter Nominal Min Max HumidityRestricted Rights Legend Certification WarrantyLimitation of Warranty Exclusive RemediesSafety Symbols Do not clean with fluidsAvertissement Service et ajustementService non autorisé Symboles des sécuritéDeclaration of Conformity