HP Broadband Service Analyzer manual Declaration of Conformity

Page 22

DECLARATION OF CONFORMITY

According to ISO/IEC Guide 22 and EN 45014

Manufacturer’s Name

Hewlett-Packard Australia Ltd

Manufacturer’s Address

Communications Measurements Division Australia

 

347 Burwood Highway

 

 

Burwood East 3151

 

 

Victoria, Australia

 

declares that the product:

 

 

Product Name

25.6 Mb/s Interface Pod

 

Model Numbers

HP E5129A

 

Product Options

This declaration covers all options of the above product.

conforms to the following product specifications:

 

Safety

EN 61010-1: 1993/IEC 1010-1: 1990 + A1

EMC

EN 55011:1991/CISPR 11:1990 (Group 1, Class A1)

 

EN 50082-1:1992

 

 

IEC 801-2:1991 2

4 kV CD, 8 kV AD

 

IEC 801-3:1984

3 V/m

 

IEC 801-4:1988

0.5 kV Signal Lines, 1 kV Power Lines

Supplementary Information

This product herewith complies with the requirements of the Low Voltage

 

Directive 73/23/EEC and the EMC Directive 89/336/EEC.

 

1The product meets the listed specifications when installed in an HP

E5200A with interface pods installed in both ports.

2Bit error performance will be reduced under these conditions.

Melbourne, Australia, July 1996 Issue 1 Graeme Cobb - Quality Manager

European Contact: Your local Hewlett-Packard Sales and Service Office or Hewlett-Packard GmbH, Department ZQ/ Standards Europe, Herrenberger Straße 130, D-71034 Böblingen, Germany (FAX +49-7031-14-3143).

Image 22
Contents Setting Up 25.6 Mb/s Interface Pod Broadband Service AnalyzerPrinting history WarrantyCopyright Product supportContents What is it? What does it do? About the 25.6 Mb/s Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal ConcentratorFront Panel at a Glance Cable and Line Connector Details Cable and Line Connector DetailsPin Signal Connector Cable ConfigurationsConnector Interface Pod User DeviceTo Set Up the Interface Pod To Set Up the Interface PodTo Insert the Interface Pod To Remove the Interface Pod To Connect to the System Under TestTo Set Up the Interface Pod Automatic Configuration Parameters See alsoClick to set the configuration To Manually Configure the Interface PodWhat to Do Next X8 Timing Marker Source SettingFill Cell Filter Setting What to Do NextCommunications Standards Standards and SpecificationsPhysical Specifications Humidity Environmental SpecificationsParameter Nominal Min Max AltitudeExclusive Remedies Certification WarrantyLimitation of Warranty Restricted Rights LegendDo not clean with fluids Safety SymbolsSymboles des sécurité Service et ajustementService non autorisé AvertissementDeclaration of Conformity