Roberts Gorden Linear Heater manual Owner Warranty Registration Card, Mail or Fax to

Page 47

®

OWNER WARRANTY REGISTRATION CARD

Mail or Fax to:

Roberts Gordon LLC •1250 William Street, P.O. Box 44 • Buffalo, NY 14240-0044 • Phone: 716-852-4400 • Fax: 716-852-0854

Toll Free: 800-828-7450www.rg-inc.com

About the Owner:

Name:__________________________________________________________________________________________________

Address:______________________________________City:_________________________State:__________Zip Code:________

Phone:_________________________ Fax:_________________________ E-mail:______________________________________

About the Installer:

Name:__________________________________________________________________________________________________

Address:______________________________________City:_________________________State:_________Zip Code:_________

Phone:__________________________Fax:_________________________E-mail:______________________________________

Purchased From (if different than installer):

Name:__________________________________________________________________________________________________

Address:______________________________________City:_________________________State:__________Zip Code:________

Phone:_________________________ Fax:_________________________ E-mail:______________________________________

About your Heater:

Model#:_______________________ Serial #:___________________________ Fuel:____________ Installation Date:__________

Type of Installation (check one):

 

 

 

 

 

 

o

Automotive

o

Manufacturing

o

Warehouse

o

Recreational

o

Aircraft

o

Public Building

o

Office

o

Retail

o

Agricultural

o

Other______________

Installation Code and Annual Inspections: All installation and service of ROBERTS GORDON® equipment must be performed by a contractor qualified in the installation and service of equipment sold and supplied by Roberts-Gordon and conform to all requirements set forth in the ROBERTS GORDON® manuals and all applicable governmental authorities pertaining to the installation, service and operation of the equipment.

To help facilitate optimum performance and safety, Roberts-Gordon recommends that a qualified contractor conduct, at a minimum, annual inspections of your ROBERTS GORDON® equipment and perform service where necessary, using only replacement parts sold and supplied by Roberts-Gordon.

These products are not for residential use.

This product is intended to assist licensed professionals in the exercise of their professional judgment.

©2009 Roberts-Gordon LLC - All rights reserved. No part of this work covered by the copyrights herein my be reproduced or

copied in any form or by any means – graphic, electronic, or mechanical, including photcopying, recording, taping, or information storage and retrieval systems – without written permission of Roberts Gordon LLC. Printed in the U.S.A.

Image 47
Contents Linear Heater Assembly Overview Linear Heater Layout Overview Description Part Number Burner Tube InstallationTube Clamp Package Tube Clamp Package InstallationCoupling and Tube Assembly DescriptionModel 1 Coupling and Tube Assembly2 Coupling and Tube Assembly Tube LengthTurbulator Installation Model Tube Section Turbulator InstallationHanger Burner Tube Reflector Description Part Number Reflector Support Package 1 Reflector, U-Clip and Reflector Support InstallationBurner Installation Optional Heater Accessories Tube Heater Assembly Overview Tube Heater Layout Overview Elbow Package Elbow Package Configuration .2.1 Elbow InstallationMinimum Distance Required Between Burner and Elbow4 Reflector Joint Installation 2 Elbow Installation3 Reflector Joint Installation Reflector Joint Detail 5 Reflector Joint Detail02712700 Reflector Side Extension 1 Bracket Installation2 Side Reflector Installation Description Part Number Lower Clearance Shield Package Distance a Extension 2 Frame Shield Installation3 Grille Installation 2 Grille End Cap InstallationCanadian Requirements VentingUnited States Requirements Unvented Operation Tube Termination Unvented OperationVertical Venting Vertical Ventilation 4 10 cm Pipe Horizontal Ventilation 4 10 cm PipeTOP View Common Side Wall VentingCommon Vertical Venting Outside Combustion Air Supply Vertical Outside Air Supply for Single Heater InstallationHorizontal Outside Air Supply for Double Heater Installation Vertical Outside Air Supply for Double Heater InstallationGAS Piping Correct Positions Line Voltage Thermostat Wiring WiringFront View Low Voltage Thermostat WiringInternal Wiring Electrical Connection to the Burner Ladder DiagramTo Shut Off Heater Operation and MaintenancePre-Season Maintenance and Annual Inspection Sequence of OperationPlease see Page 49, .5 for suggested items to inspect Reflector Vicinity of the HeaterVehicles and Other ObjectsSuspension Points Burner Cup and OrificeElectrode ThermostatTroubleshooting 12.1 Troubleshooting Flow ChartTroubleshooting Natural Propane Manifold Gas Pressure Setting Top View of HeaterReplacement Parts TOP View Rear ViewDescription Part Number Pipe Connection General SpecificationsDimensions GAS Pressure AT ManifoldLimitations on Authority Representatives Warranty is Void ifROBERTS-GORDON LLC will PAY for ROBERTS-GORDON LLC will not PAY forPage Mail or Fax to Owner Warranty Registration CardPage Page Heater Fire HazardKeep all flammable objects, liquids and vapors the minimum Required clearances to combustibles away from heater