Toshiba MMK-AP0092H, MMK-AP0122H Installation of Indoor Unit, Selection of Installation Place

Page 8

2 SELECTION OF INSTALLATION PLACE

Remote controller

A place where there are no obstacles such as a curtain that may block the signal from the indoor unit.

Do not install the remote controller in a place exposed to direct sunlight or close to a heating source, such as a stove.

Keep the remote controller at least 1m apart from the nearest TV set or stereo equipment. (This is necessary to prevent image distur-bances or noise interference.)

The location of the remote controller should be determined as shown below.

Indoor unit

(Side view)

(Top view)

 

 

7

 

Indoor unit

5

m

m

 

 

 

 

 

 

 

 

 

 

45˚

75˚

 

Reception

Reception range

Remote controller

range

 

 

* : Axial distance

 

5

 

m

45˚

7 m

*

Remote controller

3 INSTALLATION OF INDOOR UNIT

WARNING

Install the air conditioner certainly to sufficiently withstand the weight.

If the strength is insufficient, the unit may fall down resulting in human injury.

Perform a specified installation work to guard against strong wind or earthquake.

An incomplete installation can cause accidents by the units falling and dropping.

REQUIREMENT

Strictly comply with the following rules to prevent damage of the indoor units and human injury.

Do not put a heavy article on the indoor unit. (Even units are packaged)

Carry in the indoor unit as it is packaged if possible. If carrying in the indoor unit unpacked by necessity, be sure to use buffering cloth, etc. to not damage the unit.

To move the indoor unit, do not apply force to the refrigerant pipe, drain pan, foamed parts, or resin parts, etc.

Carry the package by two or more persons, and do not bundle it with PP band at positions other than specified.

Be careful to the following items when installing the unit.

Considering air discharge direction, select an installation place where discharge air can circulate evenly in a room. Avoid to install the unit at place with “NO GOOD” mark in the right figure.

OK

NO GOOD

 

 

Bad installation place

Good installation place

 

: Not cooled well.

 

 

Cooled well all over.

 

 

 

 

 

 

Screen

5

Image 8
Contents MMK-AP0072H, MMK-AP0092H, MMK-AP0122H Adoption of NEW Refrigerant Contents Refrigerant piping OthersSeparate sold parts To Disconnect the Appliance from Main Power Supply Precautions for SafetyNew Refrigerant Air Conditioner Installation Selection of Installation Place Precautions for SafetyInstallation place Installation spaceInstallation diagram of Indoor and outdoor units Remote controller Installation of Indoor UnitSelection of Installation Place Cutting a hole Mounting the installation plateWhen the installation plate is directly mounted on the wall Piping and Drain Hose Installation Piping and drain hose formingLeft- hand connection with piping Case of right or left pipingCase of bottom right or bottom left piping Indoor Unit Fixing DrainagePiping material and dimensions Refrigerant PipingPermissible pipe length and permissible height difference Pipe Forming/End PositioningRefrigerant Piping Connection of refrigerant pipeAirtight test/Air purge, etc Open fully valves of the outdoor unit Gas leak checkPower supply specifications Electric WorkWiring connection Electric WorkWiring connection for flow selector unit How to connect the wiring of flow selector unitRemote controller wiring Wiring between indoor and outdoor unitsAddress setup Wiring diagramApplicable Controls Exchange of applicable control setupBasic operation procedure for setup exchange Adjustment of air direction Applicable ControlsChange of lighting time of filter sign To secure better effect of heatingHow to execute test operation Case of wired remote controllerTest RUN Before test operationTest RUN Check wiring/piping of indoor and outdoor unitsCheck transmission of remote controller Confirmation and check TroubleshootingConfirmation of error history Troubleshooting Check code listCheck method TerminologyRemote Error detected by TCC-LINK central control device Indication Auxiliary codeNew check code Difference between the new check code and the current systemCheck of Concentration Limit Confirmation of Indoor Unit Setup Indoor unit setup check sheet