Installation space
Reserve space required to install the indoor unit and for service work.
Keep 100mm or more for clearance between top plate of the indoor unit and the ceiling surface.
Installation diagram of Indoor and outdoor units
Before installing the wireless remote controller
•With the remote controller cover open, load the batteries supplied correctly, observeing their polarity.
2Wireless remote controller Cover
3 Batteries
or170mm more
Hook
100 mm or more
Hook
1Installation 
plate
or170mm more
Shield pipe
For the rear left and left piping
Wall
Insert the cushion between the indoor unit and wall, and tilt the indoor unit for better operation.
Do not allow the drain hose to get slack
|
| Air |
|
| filter |
(Attach |
|
|
to |
|
|
the | front | panel) |
| ||
|
|
6Pan head wood screw
2 Wireless remote controller
4 Remote control holder
∗When installing the Flow Selector Unit (FS Unit), keep a space more than 300mm for wiring work.
Cut the piping hole sloped slightly
Make sure to run the drain hose sloped downward.
The auxiliary piping can be connected the left, rear left, rear right, right, bottom right or bottom left.
Right |
|
|
Rear right | Rear left | Left |
Bottom right | Bottom left | |
|
| |
Installation place
•A place which provides the spaces around the indoor unit as shown in the above diagram.
•A place where there is no obstacle near the air inlet and outlet.
•A place that allows easy installation of the piping to the outdoor unit.
•A place which allows the front panel to be opened.
CAUTION
•Direct sunlight to the indoor unit’ s wireless receiver should be avoided.
•The microprocessor in the indoor unit should not be too close to RF noise sources. (For details, see the owner’ s manual.)
4