Resetting the Password Jumper – Model 7300/7500
To disable the
1.Shut down the operating system properly, then turn off the computer and any external devices, and disconnect the power cord from the power outlet.
2.With the power cord disconnected, press the power button again to drain the system of any residual power.
WARNING! To reduce the risk of personal injury from electrical shock and/or hot surfaces, be sure to disconnect the power cord from the wall outlet, and allow the internal system components to cool before touching.
CAUTION: When the computer is plugged in, the power supply always has voltage applied to the system board even when the unit is turned off. Failure to disconnect the power cord can result in damage to the system.
Static electricity can damage the electronic components of the computer or optional equipment. Before beginning these procedures, ensure that you are discharged of static electricity by briefly touching a grounded metal object. See the Safety & Regulatory Information guide for more information.
3.Remove the access panel.
4.Locate the CMOS/password header.
NOTE: The password jumper is blue so that it can be easily identified. For assistance locating the password jumper and other system board components, see the Illustrated Parts & Service Map (IPSM). The IPSM can be downloaded from http://www.hp.com/support.
5.Remove the jumper from pins 5 and 3.
6.Place the jumper on pins 3 or 1 for
7.Put the jumper back on pins 5 or 3.
8.Replace the access panel.
9.Reconnect the external equipment.
10.Plug in the computer and turn on power. Allow the operating system to start.
11.To establish new passwords, use Computer Setup.
Resetting the Password Jumper – Model 7300/7500 213