York DY 060, DY 048 warranty Unit Dimensions Rear View, Minimum Clearances

343615-YTG-B-0308

FIGURE 7 - UNIT DIMENSIONS (REAR VIEW)

Filter Access
Blower Motor Access
Dot Plugs
Field-Supplied Disconnect
Switch Location
Mounting Bracket for
Disconnect Switch	A,B
(Field Supplied)
	Wiring Entry	Control Box Access
	(See Detail “B”)

Disconnect Switch Location and Motor Access Panel for Unit with “Belt-Drive” Option

FIGURE 8 - DISCONNECT/BLOWER ACCESS LOCATION TABLE 28: UTILITIES ENTRY

HOLE	OPENING SIZE (DIA.)	USED FOR
A	7/8” KO1	Control Wiring2	Side
			Bottom
B	2” KO1	Power Wiring	Side
			Bottom
C	1-5/8” KO	Gas Piping (Front)
D	1-1/2” KO	Gas Piping (Bottom)

1.Opening in the bottom to the unit can be located by the side in the insulation.

2.Do not remove the 2” knockout ring.

TABLE 29: MINIMUM CLEARANCES

LOCATION	CLEARANCE
Front	24” (Cooling/Electric Heat)
	32” (Gas Heat)
Rear	12” (Less Economizer)
	36” (With Economizer or Fixed
	Air/Motorized Damper)
Left Side (Filter Access)	24” (Less Economizer)
	36” (With Economizer)
Right Side (Cond. Coil)	24”
Below Unit1	0”
Above Unit2	72” (For
	Condenser Air Discharge)

1.Units may be installed on combustible floors made from wood or class A, B, or C roof covering material.

2.Units must be installed outdoors. Overhanging struc- tures or shrubs should not obstruct condenser air dis- charge outlet.

28 Johnson Controls Unitary Products