HP XA manual Audio Controller, Host Interface, Audio Chip, Specifications, Feature Description

Page 46

2 System Board

Devices on the ISA Bus

Audio Controller

The HP Kayak XA PC Workstation has an audio chip (AD1816) integrated on the system board. This single chip is a Plug and Play multimedia audio subsystem for concurrently processing multiple digital streams of 16-bit stereo audio.

Host Interface

The AD1816 audio chip contains all necessary ISA bus logic on chip. This

 

logic includes address decoding for all onboards resources, control and signal

 

interpretation, DMA selection and control logic, IRQ selection and control

 

logic, and all interface configuration logic.

Audio Chip

It is driven from the ISA bus, and has the following specification:

Specifications

Feature:

Description:

 

 

Digitized Sounds

16-bit and 8-bit stereo sampling from 4 kHz to 55.2 kHz

 

Programmable sample rates with 1 Hz resolution

 

Hardware Full Duplex Conversion

 

16-bit software-based real-time audio compression/

 

 

decompression system

 

 

Music Synthesizer

Integrated OPL3 compatible music synthesizer

 

 

Mixer

AC’97 and MPC-3 audio mixer

 

Input mixing sources: microphone, LINE In,

 

 

CD Audio, AUX Audio, and digitized sounds

 

Output mixing of all audio sources to the LINE Out or

 

 

integrated PC Workstation speaker

 

Multiple source recording and Left/Right channels

 

 

swapping or mixing

 

 

Line Input

Input impedance: 15 kohms

 

Input range: 0 to 2 Vpp

 

 

Line Output

Stereo output of 5 mW per channel with headphone

 

 

speakers (impedance >600 ohms)

 

 

 

Audio Front Panel

Microphone input jack

 

Stereo output jack

 

Master volume control potentiometer

 

 

 

46

Image 46
Contents Technical Reference Manual Hardware and Bios Page Preface Bibliography How to use this online guide Page Contents Interface Devices and Mass-Storage Drives HP Bios Power-On Self-Test and Error Messages System Overview Rear view Package for the Desktop ModelsFront view System Overview Package for the Desktop ModelsPackage for the Minitower Models HP Kayak XA PC Workstation Overview Minitower Hardware Control Panel Hardware Control PanelSystem Overview Hardware Control Panel Physical Characteristics Specifications and Characteristic DataElectrical Specifications Min Safety StandardEfficiency Max 11.0Max Current at +5 Voltage range 90-140Maximum input current +3.3 V and +5 Current at -5 Current at +5V standbyDesktop Parameter Total Rating Current at +12 Current at -12Environmental Specifications Desktop and Minitower Access HP World Wide Web DocumentationWhere to Find the Information Routines Post GuideSystem board Peripheral DevicesSystem Overview Documentation System Board System Board and Backplane Boards System Board System Board and Backplane BoardsDesktop Backplane PCI Mapping Table Device DesktopBackplane front view PCI Device Slot#Not used Architectural View System Board Architectural ViewPL Bus Interface Chip-SetPAC Chip 440LX PCI Bus InterfaceSystem Clocking AGP Bus InterfaceRead/Write Buffers Main Memory ControllerPIIX4, PCI/ISA Bridge Chip 82371AB Second Level CacheIDE Controller ISA Bus InterfaceSMBus Controller USB ControllerSerial Eeprom Counter / TimerCache Memory Intel Pentium II Microprocessor Devices on the Processor-Local BusSystem Board Devices on the Processor-Local Bus Plastic clips Bracket pillars Heat sink Bus Frequencies SwitchLocal Bus Main Memory Bus Error Correcting Code OperationSystem Board Main Memory Bus PCI Device Devices on the PCI BusIntegrated Drive Electronics IDE Name NumberUniversal Serial Bus USB Controller Other PCI Accessory DevicesPlug and Play Accelerated Graphics Port AGP Controller System Board Accelerated Graphics Port AGP ControllerDevice PCI Bus # Pentium II Processor 66 MHz System Board Devices on the SM Bus Devices on the SM BusSerial Eeprom Device SM Bus AddressLM75 Chip Main PLLSerial / parallel Devices on the ISA BusSuper I/O Controller NS ControllerAudio Controller SpecificationsFeature Description Host InterfaceFlash Eeprom Closed System Board SwitchesSwitch Switch Function Default OpenBios Update Crisis Recovery Procedure Updating the system Little BenOther ISA Accessory Devices Check the accessory board’s documentation if you are unsureSystem Board Devices on the ISA Bus Interface Devices and Mass-Storage Drives Cirrus 5465 Graphics Controller Chip Page Connectors Video MemoryRefresh rates Available Video ResolutionsResolution 640 60, 75, 85 Hz 800Scsi / LAN Combo Board PCI InterfaceConnector Description Location 10BT/100TX PCI LAN ConnectorUltra wide 16-bit Scsi connector Scsi InterfaceInterface Features PCI Interface External 8-bit Scsi connectorScsi / PCI LAN Combo Board Features Scsi Interface10BT/100TX LAN Controller Remote Power On 10BT/100TX LAN FeaturesSupporting RPO Installing Two LAN Remote Power On Cards Hard Disk Drives Mass-Storage DrivesFlexible Disk Drives CD-ROM Drives Features Panasonic CD-ROM CD-585-BBuffer Memory Size Kbytes Status Panel Connector Pin Signal Connectors and SocketsIDE Connector Pin Signal Flexible Disk Drive Data Connector Pin SignalExtStart Connector Bit Scsi Connector Bit Scsi Connector Pin SignalAUX Connector Pin Signal CD Audio Connector Pin SignalPin Signal Package Intrusion J8VGA DB Connector Pins Standard VGA Vesa Pass-Through ConnectorVGA Connector Socket Pin LayoutsPage HP Bios Using the HP Setup Program HP/Phoenix Bios SummaryHP/Phoenix Bios Summary Advanced Menu Security Default Settings You Can Change Symbios Logic Scsi Configuration UtilityStarting the Scsi Configuration Utility Power-On from Space-Bar Power Saving and ErgonometrySoft Power Down Bios Addresses System Memory MapHP I/O Port Map I/O Addresses Used by the System1 Address Ports FunctionDMA controller Interrupt Request Description HP Bios Power-On Self-Test and Error Messages For example, if the error 0101 52 is displayed Order in Which the Tests are PerformedPost Routine Description Code Post Routine Description Post Routine Description Detect and install external parallel ports Detect and install external RS 232 portsConfigure non-MCD IDE controllers Configure Motherboard Configurable DevicesPost done prepare to boot operating system Enter SetupCheck for errors Terminate QuietBootFollowing are for boot block in Flash ROM F1= Continue, F2= Setup, Enter= View System Error Error Message SummaryPower-On Self-Test and Error Messages Error Message Summary Enter= View System ErrorCause / Symptom 0512h HDD # 2 self-test error 0510h HDD # 0 self-test error0511h HDD # 1 self-test error 0513h HDD # 3 self-test errorMessage Beep Codes Beep PatternLights on the Hardware Control Panel Appendix Video Modes Standard VGA ModesColors Extended Video ModesType Refresh MHz 94.5 44.978.7 102135 108126 157162 104Refresh Mode Bios Modes SupportedResolution MHz DAC Maximum Refresh Rates1024 600106 1200 Type107 Appendix Video Modes 108