HP XA manual Advanced Menu

Page 75

4 HP BIOS

HP/Phoenix BIOS Summary

Advanced Menu

The Advanced Menu does not have the same structure as the Main Menu and Power Menu. Instead of presenting a list of fields, it offers a list of sub-menus. The Advanced Menu contains the following sub-menus:

•Memory and Cache. Define how to configure the specified block of memory.

•Video. Set the best ergonomic refresh rate supported by the display. This feature, can also be used to set the preferred refresh rate for each graphic mode.

•Flexible Disk Drives. Enable or disable the on-board flexible disk controller.

•IDE Devices. Configure IDE Primary and Secondary devices.

•SCSI Interface. Enable or disable the integrated SCSI interface. In the Ultra SCSI item, the Auto option will enable or disable automatically the Ultra SCSI by the BIOS, depending on whether external SCSI devices are detected or not.

•Integrated Network Interface. Enable or disable the integrated network interface. This feature must be enabled when an ethernet card is installed.

•Integrated Peripherals. Enable or disable the on-board parallel and serial ports at the specified address.

•Integrated USB Interface. Enable or disable the integrated USB (Universal Serial Bus) interface.

•Integrated Audio Interface. Enable or disable the audio interface. This feature is useful on non plug-and-play operating systems, because the integrated audio chip is plug-and-play.

•PCI Devices. Enable this option if you need the BIOS to set the PCI Bus Master bit. This could be necessary for some older PCI accessory boards.

•ISA Resource Exclusion. reserves interrupts for legacy ISA devices to prevent conflict with PCI/PnP devices.

75

Image 75

Contents Technical Reference Manual Hardware and Bios Page Preface Bibliography How to use this online guide Page Contents Interface Devices and Mass-Storage Drives HP Bios Power-On Self-Test and Error Messages System Overview System Overview Package for the Desktop Models Package for the Desktop ModelsFront view Rear viewPackage for the Minitower Models HP Kayak XA PC Workstation Overview Hardware Control Panel Minitower Hardware Control PanelSystem Overview Hardware Control Panel Specifications and Characteristic Data Physical CharacteristicsElectrical Specifications Max 11.0 Safety StandardEfficiency Min+3.3 V and +5 Current at -5 Current at +5V standby Voltage range 90-140Maximum input current Max Current at +5Current at +12 Current at -12 Desktop Parameter Total RatingEnvironmental Specifications Desktop and Minitower Documentation Access HP World Wide WebWhere to Find the Information Peripheral Devices GuideSystem board Routines PostSystem Overview Documentation System Board System Board System Board and Backplane Boards System Board and Backplane BoardsPCI Device Slot# DesktopBackplane front view Desktop Backplane PCI Mapping Table DeviceNot used System Board Architectural View Architectural ViewPCI Bus Interface Chip-SetPAC Chip 440LX PL Bus InterfaceMain Memory Controller AGP Bus InterfaceRead/Write Buffers System ClockingSecond Level Cache PIIX4, PCI/ISA Bridge Chip 82371ABUSB Controller ISA Bus InterfaceSMBus Controller IDE ControllerCounter / Timer Serial EepromCache Memory Devices on the Processor-Local Bus Intel Pentium II MicroprocessorSystem Board Devices on the Processor-Local Bus Plastic clips Bracket pillars Heat sink Switch Bus FrequenciesLocal Bus Error Correcting Code Operation Main Memory BusSystem Board Main Memory Bus Name Number Devices on the PCI BusIntegrated Drive Electronics IDE PCI DeviceOther PCI Accessory Devices Universal Serial Bus USB ControllerPlug and Play System Board Accelerated Graphics Port AGP Controller Accelerated Graphics Port AGP ControllerDevice PCI Bus # Pentium II Processor 66 MHz Device SM Bus Address Devices on the SM BusSerial Eeprom System Board Devices on the SM BusMain PLL LM75 ChipController Devices on the ISA BusSuper I/O Controller NS Serial / parallelHost Interface SpecificationsFeature Description Audio ControllerFlash Eeprom Open System Board SwitchesSwitch Switch Function Default ClosedBios Update Crisis Recovery Procedure Little Ben Updating the systemCheck the accessory board’s documentation if you are unsure Other ISA Accessory DevicesSystem Board Devices on the ISA Bus Interface Devices and Mass-Storage Drives Cirrus 5465 Graphics Controller Chip Page Video Memory Connectors640 60, 75, 85 Hz 800 Available Video ResolutionsResolution Refresh ratesPCI Interface Scsi / LAN Combo BoardScsi Interface 10BT/100TX PCI LAN ConnectorUltra wide 16-bit Scsi connector Connector Description LocationScsi Interface External 8-bit Scsi connectorScsi / PCI LAN Combo Board Features Interface Features PCI Interface10BT/100TX LAN Controller 10BT/100TX LAN Features Remote Power OnSupporting RPO Installing Two LAN Remote Power On Cards Mass-Storage Drives Hard Disk DrivesFlexible Disk Drives Features Panasonic CD-ROM CD-585-B CD-ROM DrivesBuffer Memory Size Kbytes Flexible Disk Drive Data Connector Pin Signal Connectors and SocketsIDE Connector Pin Signal Status Panel Connector Pin SignalExtStart Connector Bit Scsi Connector Pin Signal Bit Scsi ConnectorPackage Intrusion J8 CD Audio Connector Pin SignalPin Signal AUX Connector Pin SignalVesa Pass-Through Connector VGA DB Connector Pins Standard VGASocket Pin Layouts VGA ConnectorPage HP Bios HP/Phoenix Bios Summary Using the HP Setup ProgramHP/Phoenix Bios Summary Advanced Menu Security Symbios Logic Scsi Configuration Utility Default Settings You Can ChangeStarting the Scsi Configuration Utility Power Saving and Ergonometry Power-On from Space-BarSoft Power Down System Memory Map Bios AddressesAddress Ports Function HP I/O Port Map I/O Addresses Used by the System1DMA controller Interrupt Request Description HP Bios Power-On Self-Test and Error Messages Order in Which the Tests are Performed For example, if the error 0101 52 is displayedPost Routine Description Code Post Routine Description Post Routine Description Configure Motherboard Configurable Devices Detect and install external RS 232 portsConfigure non-MCD IDE controllers Detect and install external parallel portsTerminate QuietBoot Enter SetupCheck for errors Post done prepare to boot operating systemFollowing are for boot block in Flash ROM Enter= View System Error Error Message SummaryPower-On Self-Test and Error Messages Error Message Summary F1= Continue, F2= Setup, Enter= View System ErrorCause / Symptom 0513h HDD # 3 self-test error 0510h HDD # 0 self-test error0511h HDD # 1 self-test error 0512h HDD # 2 self-test errorMessage Beep Pattern Beep CodesLights on the Hardware Control Panel Appendix Standard VGA Modes Video ModesExtended Video Modes ColorsType Refresh MHz 102 44.978.7 94.5157 108126 135104 162Maximum Refresh Rates Bios Modes SupportedResolution MHz DAC Refresh Mode600 1024106 Type 1200107 Appendix Video Modes 108