5 Power-On  Self-Test  and Error Messages
Error Message Summary
Code #  | Cause / Symptom | Short message (US)  | 
  | 
  | 
  | 
0731h  | Defective SIMM (module 1, bank 3)  | System Memory Error  | 
  | 
  | 
  | 
0732h  | Defective SIMM (module 2, bank 3)  | System Memory Error  | 
  | 
  | 
  | 
0800h  | Found lower cache size than configured  | System Cache Error  | 
  | 
  | 
  | 
0801h  | Cache   | System Cache Error  | 
  | 
  | 
  | 
0900h  | Lan (Chanteclerc)   | Integrated LAN Error  | 
  | 
  | 
  | 
0901h  | Lan (Chanteclerc) not detected (but enabled in Setup)  | Integrated LAN Error  | 
  | 
  | 
  | 
0A00h  | Plug and Play video   | DDC Video Error  | 
  | 
  | 
  | 
The following table summarizes the most significant of the problems that can be reported.
Message | Explanation or Suggestions for Corrective Action  | 
  | 
  | 
Operating system not found  | Check whether the disk, HDD, FDD or   | 
  | connected. | 
  | If it is connected, check that it is detected by POST.  | 
  | Check that your boot device is enabled on the Setup Security  | 
  | menu.  | 
  | If the problem persists, check that the boot device contains the  | 
  | operating system.  | 
  | 
  | 
Missing operating system | If you have configured HDD user parameters, check that they are  | 
  | correct. Otherwise, use HDD type “Auto” parameters.  | 
  | 
  | 
Resource Allocation Conflict   | Clear CMOS.  | 
device 0079 on system board | 
  | 
  | 
  | 
Video Plug and Play interrupted or | You may have powered your computer Off/On too quickly and the  | 
failed.   | computer turned off Video plug and play as a protection.  | 
  | 
  | 
System CMOS checksum bad - run  | CMOS contents have changed between 2   | 
Setup  | Setup for configuration.  | 
  | 
  | 
No message, system “hangs”  | Check that cache memory and main memory are correctly set in  | 
  | their sockets.  | 
  | 
  | 
Other | An error message may be displayed and the computer may “hang”  | 
  | for 20 seconds and then beep. The POST is probably checking for a  | 
  | mass storage device which it cannot find and the computer is in  | 
  | |
  | configuration.  | 
  | 
  | 
4 - 4 - 2 - 4  | Switch 9 is not correctly set or flash is corrupted. The BIOS update  | 
  | crisis recovery procedure is to be used.  | 
  | 
  | 
96