HP Ultrium tape drive 960i manual Firmware is being, Reprogrammed, Service, Completion, Complete

LED		Cause	Action required
Sequence
		Ready is FLASHING fast.	None.
		The drive is	Do not reset or power cycle the drive.
		downloading firmware.
		Ready is OFF, others are	None.
		ON.	Do not reset or power cycle the drive.
		Firmware is being
		reprogrammed.
		Clean is FLASHING.	Load the Ultrium cleaning cartridge. See page 28 for
		The drive requires	supported cartridges and instructions.
		cleaning.	If the Clean LED is still flashing when you load a new
			or known data cartridge after cleaning, call for
			service.
		Ready is FLASHING and	None. The cleaning cartridge will eject on
		Clean is ON.	completion.
		Cleaning is in progress.	The cleaning cycle can take up to 5 minutes to
			complete.
		Tape Error is FLASHING.	Unload the tape cartridge. Make sure that you are
		The drive believes the	using the correct format cartridge; an Ultrium data
			cartridge or Ultrium Universal cleaning cartridge.
		current tape or the tape
		just ejected is faulty.	(See page 28.)
			Reload the cartridge. If the Tape Error LED still flashes
			or starts flashing during the next backup, load a new
			or known, good cartridge.
			If the Tape Error LED is now off, discard the 'suspect'
			tape cartridge. If it is still on, call for service.
		The tape is ejected	Write-protect the cartridge by sliding the red switch
		immediately and Tape	on the tape cartridge. The tape can be loaded and
	or	Error is FLASHING, or	the data read. Once the data is recovered, the
		Drive Error FLASHES on	cartridge must be discarded.
		unloading tape.
		The tape cartridge
		memory (CM) may be
		faulty.
		Drive Error FLASHING.	Load a new cartridge. If the error persists, power
		The drive mechanism	cycle or reset the drive.
		has detected an error.	If the Drive Error LED remains on, call for service.

44