HP 1000ux, 1900ux, 2300ux manual Running an internal test, Micromove

Navigation

Table 6: Information logs (Continued)

	Log name	Description
	— *MICROMOVE 6	Sixth jukebox micro-move for the original move
	#	command issued prior to the failure. (This is the
		last to be logged.)
■	*MICROMOVE ER #	Micro-move error that occurred.
■	TOP or BOTTOM	Displays either TOP or BOTTOM indicating
	PICKER	which side of the disk transport mechanism was
		active at the time of the error.
■	NORTH or SOUTH	Displays either NORTH or SOUTH indicating
	THUMB	which thumb on the transport mechanism was
		active at the time of the error.

Running an internal test

READY > ADMIN* >TEST*

This section describes self-diagnostic tests that are available on the jukebox.

Caution: Diagnostic tests should be run only by an authorized service representative. Descriptions of the self-diagnostic tests are included in this manual for information purposes only. If not properly completed, some of the internal diagnostic tests can corrupt your file system. In some rare instances, your service representative may request that you run specific tests to provide information before they come to your site, or you may receive a control panel message to run a specific test.

1.With READY displaying on the control panel, press NEXT until ADMIN* displays.

2.Enter the administration password (see “Entering the administration menu password” on page 44).

3.TEST* displays. Press ENTER.

4.Press NEXT until the name of the test you want to run displays and then press ENTER to start the test.

44 HP StorageWorks 1000ux/1900ux/2300ux Optical Jukebox User’s Guide