HP 2100 ER Assemble the L-brackets to the Fibre Bridge, Assembling L-brackets to the Fibre Bridge

Setting Up the Fibre Bridge

Mounting the Fibre Bridge in a Rack

Assemble the L-brackets to the Fibre Bridge

1. Facing the back of the Fibre Bridge, position the first L-bracket with the mounting tab toward the back of the rack and pointing away from the unit, as shown in Figure 2-1.

2. Insert 6x32 screws through the first and third holes from the

	mounting tab and tighten. Use the first and third holes (from the
	mounting tab end of the bracket) for mounting in a Hewlett-Packard
	rack. (Non-HP racks may require mounting holes number two and
	four. See note below.)
	3. Follow the same procedure for the second L-bracket.
NOTE	For non-HP racks, allow for cable turn: A minimum distance of 5 inches
	(125 mm) is required between the back of the Fibre Bridge and the
	backplane of the rack. When installing in racks where the mounting
	holes in step 2 produces a distance less than 5 inches (125 mm), use the
	second and fourth holes when attaching the mounting bracket to the
	Fibre Bridge.
Figure 2-1	Assembling L-brackets to the Fibre Bridge

H
Not	Suitable
		for H
		ard D
		rive S
		ubsystems

2-4 Chapter 2