HP 2100 ER manual Install the Fibre Bridge in the Rack, Mount the Fibre Bridge in the Rack

		Setting Up the Fibre Bridge
		Mounting the Fibre Bridge in a Rack
	Install the Fibre Bridge in the Rack
	1.	Facing the back of the rack, install a total of four clip nuts above any
		existing product, two into each of the rails. Install the clip nuts so
		that the top nut aligns with the top hole of the L-bracket and the
		other with the bottom hole. (Figure 2-2).
		To ensure level mounting, verify that the clip nuts are in the same
		position on the right and left rails.
NOTE	The Fibre Bridge mounts from the back of the rack. All user functionality
	is located on the back of the unit; no access to the front is required.
	2.	Holding the Fibre Bridge in position, align the holes in the mounting
		brackets with the holes in the clip nuts.
	3.	Install four 10x32 screws into the clip nuts and hand-tighten.
	4.	Tighten all four screws.
	5.	Install the front filler panel (supplied by the rack vendor) and apply
		the decal.
Figure 2-2	Mount the Fibre Bridge in the Rack

Setting Up the Fibre Bridge

Chapter 2 2-5