HP 2100 ER manual Fibre Bridge Connection, Basic Configuration, DLT and MO Libraries

		Setting Up the Fibre Bridge
		Installing Cables
	3.	Connect one end of the optical cable into the GBIC on the Fibre
		Bridge and the other end into the GBIC on the Fibre Channel HBA in
		the host.
	4.	Connect the power cord from the Fibre Bridge to an grounded outlet.
	5.	Confirm that all cable ends are connected securely and both ends of
		the SCSI bus are properly terminated, as shown in Figure 2-3 on page
		2-7.
	6.	Go to “Powering on the System” in Chapter 3.
Figure 2-3	Fibre Bridge Connection, Basic Configuration
	(DLT and MO Libraries)

Setting Up the Fibre Bridge

Chapter 2 2-7