Troubleshooting Guide
Troubleshooting
| 2. Make sure the libraries, Fibre Bridge, and hubs (DLT only) are |
| powered on and connected appropriately before powering on |
| workstations. If they were not connected, powered on, and configured |
| properly before the NT workstation was powered on, restart the |
| workstation (and any other on the loop, one at a time) so they can |
| |
|
|
NOTE | (DLT Only) Do not restart multiple NT workstations on a Fibre Channel |
| loop at the same time. Allow each workstation to complete the process |
| and display the NT login prompt before turning on the next computer. If |
| more than one workstation is powered on at the same time, only one will |
| locate devices on the Fibre Channel loop. This sequential process is |
| particularly critical when recovering from a power failure. |
|
|
Guide | Troubleshooting |
|
|
Chapter 4 |