HP 4110v, 4110xi manual Chapter

Page 12

chapter 3

3Tap the stack on a flat surface to align the edges of the paper, and then check the paper for the following:

–Make sure it is free of rips, dust, wrinkles, and curled or bent edges.

–Make sure all the paper in the stack is the same size and type, unless you are working with photo paper.

4Insert paper into the paper tray print-side down until it stops. To avoid bending the paper, make sure you do not push the paper in too far, or push too hard. If you are using letterhead, insert the top of the page first.

Be careful not to use too much or too little paper. Check that the stack of paper contains several sheets but is no higher than the top of the paper- width guide.

5Slide the paper-width guide in until it stops at the edge of the paper. Make sure that the paper stack lies flat in the paper tray and fits under the tab of the paper-width guide.

6Extend the output-tray.

8	hp officejet 4100 series

Image 12

Contents Hp officejet 4100 series all-in-one Reference guideSafety information Copyright Hewlett-Packard CompanyContents Index Get help Help DescriptionChapter Front panel features Quick startButton Purpose Use your hp officejet with a computer Review the hp photo & imaging directorFeature Feature Purpose Load originals and load paper Load originalsLoad paper Chapter Load envelopes Load 4 x 6 inch photo paper Load postcardsTips for loading other types of paper in the paper tray Paper TipsSet the paper type Set the paper sizeUse the copy features Make copiesMake a copy Increase copy speed or qualitySet the number of copies Reduce or enlarge a copyMake copies lighter or darker Enhance text sharpness and photo colorsChange settings for all copy tasks Perform special copy jobsCopy a photo Copy options Fit a copy toUse the scan features Scan an originalStop scanning Use the fax features Change settings and use speed dials before sending a faxSend a fax Send a fax from your hp officejetSend a color fax Schedule a faxCancel a scheduled fax Receive a faxSet the number of rings before answering Receive a fax manuallyControl resolution and contrast Change resolutionPrint reports Generate reports automaticallyChange other fax settings Press Enter to accept the setting you selectedChange contrast Redial a number automaticallyEdit or cancel fax forwarding Forward faxes to another numberUse error correction mode Adjust the volumeSet automatic reduction Set up speed dialing Create individual speed-dial settingsChange the answer ring pattern distinctive ringing Set basic fax settings using the front panel Delete speed-dial settingsSet the date and time Set the fax headerEnter text Check for dial toneSetup menu for fax commands Following fax settings are available in the Setup menuFax job menu Chapter Clean the glass Maintain your hp officejetClean the white strip Clean the exteriorWork with print cartridges Print a self-test reportReplace the print cartridges Chapter Restore factory defaults Clean the print cartridgesAlign the print cartridges Set the prompt delay time Self-maintenance soundsSet scroll speed Setup menu options Following options are available from the Setup buttonChapter Additional setup information Possible installation problemsRemove and reinstall your hp officejet software Additional setup information Additional troubleshooting help Technical information Doc statement / déclaration de conformité CanadaGeräuschemission Call in the U.S. during warranty Hp supportCall elsewhere in the world Country/region Hp technical supportCall in Australia post-warranty Prepare your unit for shipmentHp officejet 4100 series Hp distribution center Chapter Warranty information Express serviceExtent of limited warranty Limitations of warranty Limitations of liabilityLocal law Reference guide Chapter Index NumericsHp officejet 4100 series Page Chapter Declaration of conformity Q1608-90163 Order mediaOrder print cartridges Print cartridges Hp reorder number

Related manuals

Manual 2 pages 4.77 Kb

Manual 2 pages 28.4 Kb