Tefal FV4560C0, FV4560E0 manual If there is a problem?, Problem Possible Cause Solution

1800115635 FTJ E0:1800115635 FTJ E0 2/06/09 13:49 PAGE 19

If there is a problem?				GB
				D
PROBLEM	POSSIBLE CAUSE		SOLUTION
				F
Water drips from the	The chosen temperature is too		Position the thermostat in the steam range
holes in the soleplate.	low and does not allow for the		(from •• to MAX).	NL
	formation of steam.
	You are using steam while the iron		Wait until the thermostat light goes out.
				I
	is not hot enough.
	You are using the Shot of Steam		Wait a few seconds between each use of the
	button too often.		button.	E
	There is too much steam.		Reduce the steam.
	You have stored the iron horizon-		See the section "Storing your iron".	P
	tally, without emptying it and
	without setting it to .			DK
Brown streaks come		You are using chemical descaling	Do not add any descaling agents to the water
through the holes in the		agents.	in the water tank.	N
soleplate and stain the		You are not using the right type of	Perform a self-cleaning operation and consult
linen.		water.	the chapter "What water should I use?".	S
		Fabric fibres have accumulated in	Perform the self-cleaning operation and clean	FIN
		the holes of the soleplate and are	the soleplate with a damp sponge. Vacuum
		burning.	the holes of the soleplate from time to time.	GR
		Your linen has not been rinsed	Make sure that your laundry is rinsed
		sufficiently or you have ironed a	sufficiently so as to remove any deposits of
		new garment before washing it.	soap or chemical products on new clothes.	CZ
The soleplate is dirty or		Your are ironing with an inappro-	Clean the soleplate as indicated above. Select	H
brown and can stain the		priate program (temperature too	the appropriate program.
linen.		high).
		You are using starch.	Clean the soleplate as indicated above.	SK
			Always spray starch onto the reverse side of
			the fabric to be ironed.	HR
There is little or no		The water tank is empty.	Fill it.
				SLO
steam.		The anti-calc valve is dirty.	Clean the anti-calc valve.
		Your iron has a build-up of scale.	Clean the anti-calc valve and carry out a self-
			clean.	RO
		Your iron has been used dry for too	Carry out a self-clean.
		long.		SR
The soleplate is scrat-		You have placed your iron flat on a	Always set your iron on its heel.	BG
ched or damaged.		metallic rest-plate or ironed over a	Do not iron over zips.
		zip.
				PL
Steam or water come		The steam control is not set to the	Check that the steam control is set to the
from the iron as you		position.	position.	TR
finish filling the tank.		The water tank is overfilled.	Never exceeed the Max level.
				UA
The spray does not		The water tank is not filled enough.	Fill up th water tank.
spray.				EST
If you have any problem or queries, please contact our				LV
Customer Relations team first for expert help and advice.				LT
		845 602 1454 - UK / (01) 677 4003 - ROI
		or consult our website - www.tefal.co.uk		RUS
			19