GE ASH12, ASH10 installation instructions Safety Precautions

Page 2

Safety Instructions

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING.

WARNING!

For your safety, the information in this manual must be followed to minimize the risk of fire, electric shock or personal injury.

SAFETY PRECAUTIONS

Instructions Operating Instructions

■Use this appliance only for its intended purpose as described in this Owner’s Manual.

■This air conditioner must be properly installed in accordance with the Installation Instructions before it is used.

■Never unplug your air conditioner by pulling on the power cord. Always grip plug firmly and pull straight out from the receptacle.

■Repair or replace immediately all electric service cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either the plug or connector end.

■Turn the mode control OFF and unplug your air conditioner before making any repairs or cleaning.

NOTE: We strongly recommend that any servicing be performed by a qualified individual.

■For your safety…do not store or use combustible materials, gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.

■All air conditioners contain refrigerants, which under federal law must be removed prior to product disposal. If you are getting rid of an old product with refrigerants, check with the company handling disposal about what to do.

HOW TO CONNECT ELECTRICITY

Consumer Support Troubleshooting Tips Installation

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For personal safety, this appliance must be properly grounded.

The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard from this appliance.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.

Where a 2-prong wall outlet is encountered,

it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

The air conditioner should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating plate.

This provides the best performance and also prevents overloading house wiring circuits which could cause a fire hazard from overheated wires.

See the Installation Instructions, Electrical Requirements section for specific electrical connection requirements.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Air Conditioners Write the model and serial numbers here Model # Serial #Safety Precautions GEAppliances.com Installation InstructionsOperating Power Outage Recovery Feature Remote ControlFAN Mode SafetyCool Mode Air Direction-Up and Down on some modelsConsumer Support Mode ControlsInstructions Temp ControlsTips Consumer Support Air Direction-Side-to-SideGrille and Case Care and cleaning of the air conditionerHow to Insert the Batteries Outdoor CoilsTools YOU will Need Before YOU BeginElectrical Requirements Window Installation Instructions Parts IncludedRemove the Front Grille if Attached Window RequirementsStorm Window Requirements Remove the AIR Conditioner from the Case Prepare the CaseInstall the Security Bracket and the Foam TOP Window Gasket Install the Case in the WindowInstall the AIR Conditioner in the Case Through-the-Wall Installation Instructions-Optional Finish the Wall OpeningTroubleshooting Tips… Normal Operating SoundsWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration What Is Not Covered Air Conditioner WarrantyTroubleshooting Tips Consumer Support We Will ReplaceConsumer Support GE Appliances Website Schedule ServiceParts and Accessories Real Life Design StudioAcondicionadores de Aire ¡ADVERTENCIA Instrucciones de OperaciónInstrucciones Solución de problemas instalaciónApoyo al consumidor Control remoto Instrucciones de SeguridadFunción de recuperación de pérdida de energía LOW 1 BAJO, MED 2 o High 3 AltoModo de FAN Ventilador Solución deModo Cool Frio Dirección del aire-de lado a lado en algunos modelosDescripciones de enfriamiento InstalaciónControles de modo Vent Control Control de la ventilación en algunos modelos Dirección del aire-de lado a ladoApoyo al consumidor Solución Cuidado y limpieza del acondicionador de airePrecaución no Opere el Cómo insertar las bateríasHerramientas QUE Usted Necesitará Antes DE IniciarRequisitos Electricos Instrucciones para la instalación en una ventana Partes IncluidasRetire LA Parrilla Frontal SI Está Pegada Requisitos Para LA VentanaRequisitos DE UNA Ventana DE Tormentas Prepare LA Caja Retire EL Acondicionador DE Aire DE LA CajaDE LA Ventana Instale LA Caja EN LA VentanaInstale EL Acondicionador DE Aire EN LA Caja Importante Termine LA Abertura EN LA ParedApoyo al Solucionar problemasInstrucciones de Seguridad Operación Instalación Sonidos de operación normalesNotas Instrucciones de Operación InstalaciónSolución de problemas Instrucciones de Instalación Operación Lo que no está cubierto Garantía de su acondicionador de aireNosotros reemplazaremos Un añoGarantías ampliadas Soporte al Consumidor Página Web de GE AppliancesSolicite una reparación Piezas y accesorios
Top Page Image Contents