Window Installation Instructions
6INSTALL THE CASE IN THE WINDOW
ACut the window sash seal to the window width and stick the adhesive side to the bottom of the sash.
Window sash seal
BThread two type C bolts into the support brackets.
Slide the case into the window and lower the window behind the top mounting rail.
Position the brackets on the case bottom so they will be near the outermost point on the window sill. Attach the support brackets to each side of the case bottom using 4 type A screws on each side. The case should be slightly tilted to the outside. Use a level; about a 1/2 bubble will be the correct case slant to the outside.
Type A screws
Type C bolts
CLocate the 3 screw holes along the bottom front edge of the case. Center the case, side-
|
| Top mounting rail |
| |
Type B |
|
|
| |
|
|
| ||
|
|
| ||
|
|
| ||
screws |
|
| Type B | |
|
|
|
| screws |
Type B screws
DExtend the left and right accordion panels to the vertical window sashes and attach with 4 type B screws.
7INSTALL THE SECURITY BRACKET AND THE FOAM TOP WINDOW GASKET
AAttach the security bracket with a type B screw.
BCut the foam top window gasket to the window width.
CStuff the foam between the glass and the window to prevent air and insects from getting into the room.
13