GE AJCM 08 ACD Remove Locking Plate on Front Left Side, Remove ALL Shipping Pads

Page 14

Installation Instructions

INSTALLING A J-MODEL IN AN EXISTING WALL CASE

Read these instructions completely and carefully.

1REMOVE LOCKING PLATE ON FRONT LEFT SIDE

Locking

plate

Remove

screw

2REMOVE ALL SHIPPING PADS

(IF PRESENT) INSIDE AIR CONDITIONER NEXT TO COMPRESSOR

4REINSTALL LOCKING PLATE WITH TAB BEHIND WALL CASE FLANGE. TIGHTEN SCREW

5ATTACH POWER CORD TO BASE PAN WITH CLAMP

Base pan

Power cord

Clamp

6ATTACH FRONT GRILLE

An opening for the power cord is on the bottom of the front grille.

Remove shipping pads (if present)

CAREFULLY SLIDE AIR CONDITIONER BACK INTO CASE

Make sure that the tubing on the unit does not touch the wall case and that the case installation is secure.

Image 14

Contents Installation Instructions Model #Before making any repairs or cleaning New power supply cord obtained fromEither the plug or connector end Manufacturer and not repaired. DoGEAppliances.com We strongly recommend against the use of an extension cordWe strongly recommend against the use of an adapter plug Instructions Operating InstructionsAbout the controls on the air conditioner-Cool Only Models Cleaning Operating Instructions Safety InstructionsConsumer Remote Control Cooling Descriptions SafetyRemote Control Appearance may vary Consumer Support Remote ControlAbout the controls on the air conditioner-Heat/Cool Models FAN SpeedsTips Consumer Support Heating DescriptionsAbout the controls on the air conditioner Thermostat connections provide 24 V AC only Outdoor Coils Care and cleaning of the air conditionerGrille and Case Front GrilleConsumer Support Safety Air FilterHow to Insert the Batteries in the Remote Control ELECTRICAL REQUIREMENTS Amp time delay fuse or circuit breakerBefore YOU Begin Model Qualifying QuestionsTools YOU MAY Need GE KIT NumbersAttach Front Grille Remove Locking Plate on Front Left SideRemove ALL Shipping Pads Prepare Opening in Wall Support Requirements for AIR ConditionerWindow INSTALLATION-OPTIONAL Window RequirementsRemove AIR Conditioner from Case Install Sill Supports Prepare WindowMEASURE,PANELS CUT and Install Filler Mark the a and B measurements on each sideInstall Case in Window Case should have a 1/8″ minimum tilt toward the outsideInstall Window Gasket and Locking Bracket Replace AIR Conditioner in CaseCleaning Before you call for service…Operating Instructions Safety Instructions Normal Operating Sounds Consumer SupportTroubleshooting Tips Consumer Support Air Conditioner WarrantyCleaning Installation Instructions GE Will ReplaceConsumer Support GE Appliances Website Schedule ServiceParts and Accessories Real Life Design Studio