GE AJCM 08 ACD installation instructions Remove AIR Conditioner from Case

Installation Instructions

2

STORM WINDOW REQUIREMENTS

A storm window frame will not allow the air conditioner to tilt towards the outside and will keep it from draining properly. To adjust for this, attach a piece of wood to the stool.

WOOD PIECES

WIDTH: 2″

LENGTH: Long enough to fit inside the window frame.

THICKNESS: To determine the thickness, place a piece of wood on the stool to make it 1/2″ higher than the top

1/2″ higher than frame

Storm window

frame

Wood

Stool

of the storm window frame.

Attach securely with nails or screws provided by the installer.

3

REMOVE AIR CONDITIONER FROM CASE

ARemove the front grille. See the Care and Cleaning section.

BFind the locking plate located on the front left side.

CRemove the screw and the locking plate to unlock the air conditioner.

F

Remove all shipping pads (if present) inside the air conditioner next to the compressor.

Locking

plate

Remove

screw

DRemove and discard the shipping screw on the back of the air conditioner to allow removal of the air conditioner from the case.

Remove screw

Remove shipping pads (if present)

GRemove the rear grille that is taped to the back of the case. Remove the packet of screws taped to the back of the grille. While holding the grille at a 45° angle, insert it into the clips at the top of the case and push the bottom in. Keep slight upward pressure on the grille until it fits flush with the bottom of the case.

If attaching the grille
	If attaching the grille
from the outside of the	from the inside of the case,
case, use the 2 long screws.	use the 2 short screws.
Clips

E

Pull the bottom corners of the air conditioner and slide it out of the case.

Insert the 2 long screws	Insert the 2 short screws
on the outside	on the inside

17