Safety, Remote Control, Cooling Descriptions

GEAppliances.com

COOL MODE

Safety

Remote Control

1.Press COOL pad.

2.Press LOW, MED or HIGH pads to set desired fan speed.

3. Press the INCREASE +/ DECREASE – pads to set the desired temperature 60°F to 85°F in 1°F increments.

Control Panel

1.Press the MODE pad until the COOL indicator light is lit and the LOW, MED or HIGH indicator light is lit for the desired fan speed.

2.Press the INCREASE + / DECREASE – pads to set the desired temperature 60°F to 85°F in 1°F increments.

A thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler.

Set the thermostat at a higher number and the indoor air will become warmer.

NOTE: If the air conditioner is off and is then turned on while set to COOL, it will take approximately 3 minutes for the compressor to start and cooling to begin.

Cooling Descriptions

For Normal Cooling—Select the COOL mode and HIGH or MED fan with a middle set temperature.

For Maximum Cooling—Select the COOL mode and HIGH fan with a lower set temperature.

For Quieter and Nighttime Cooling—Select the COOL mode and LOW fan with a middle set temperature.

NOTE: If you switch from a COOL setting to OFF or to a fan setting, wait at least 3 minutes before switching back to a COOL setting.

Instructions Operating Instructions Care and

FAN MODE

Use the FAN mode to provide air circulation and filtering without cooling. Since fan-only settings do not provide cooling, a temperature setting will not be displayed.

Remote Control

Press FAN pad. Press LOW, MED or HIGH pads to set desired fan speed.

Control Panel

Press the MODE pad until the FAN indicator light is lit and the LOW, MED or HIGH indicator light is lit for the desired fan speed.

Cleaning Installation Instructions Troubleshooting Tips Consumer Support