GE AJCM 08 ACD About the controls on the air conditioner-Heat/Cool Models, Appearance may vary

Care and Cleaning Operating Instructions Safety Instructions

About the controls on the air conditioner—Heat/Cool Models

Appearance may vary.

Air Conditioner Controls	Remote Control
Lights beside the touch pads on the air conditioner
control panel indicate the selected settings.

Controls

ON/OFF	TIMER
Turns air conditioner on and off.	ON—When the air conditioner is off, it can
Display	be set to automatically turn on in half an
	hour to 24 hours at its previous setting.
Displays the temperature setting. Displays
	Each touch will set the time in half hours
hours when setting the timer.
	up to 10 and then in hours up to 24.

Troubleshooting Tips Installation Instructions

MODE

On the air conditioner controls, use to set COOL, HEAT or FAN mode. Indicator lights on the air conditioner controls will show the mode selected.

TEMP Increase + /Decrease – Pads

Use to set temperature when in COOL or HEAT mode.

FAN Speeds

Use to set the fan speed at LOW or HIGH. Indicator lights will show the speed selected.

To cancel the On Timer, press the ON pad until the display time disappears.

OFF—When the air conditioner is on, it can be set to automatically turn off in half an hour to 24 hours. Each touch will set the time in half hours up to 10 and then in hours up to 24.

To cancel the Off Timer, press the OFF pad until the display time disappears.

Remote Control Signal Receiver

NOTE: When the air conditioner is turned on,

it will automatically start in the setting last used.

Consumer Support

Remote Control

n	To ensure proper operation, aim the	n	Make sure nothing is between the air
	remote control at the signal receiver		conditioner and the remote control that
	on the air conditioner.		could block the signal.
n	The remote control signal has a range	n	Make sure batteries are fresh and installed
	of up to 21 feet.		correctly—see the Care and Cleaning section.

6