Components
The images shown in this installation instructions are for illustrative purpose only. Check the supplied components before starting.
∏ 2 Wall mount brackets
∏2 Screws
∏ 2 Lock pins
∏ | AC mains leads | (Saudi Arabia and Kuwait) | (Others) | ||
| (Australia and New Zealand) | ||||
|
|
|
|
|
|
|
|
|
|
|
|
∏ 1 Digital transmitter
Commercially available components (not supplied) |
|
≥ Screws for wall mounting | ≥ Screws to attach fall prevention cord to wall |
≥Fall prevention cord
≥Use commercially available screws with a nominal diameter of ‰4.0 mm that are suited to the wall material (wood, steel frame,
concrete etc.) you are attaching the wall mount brackets to.
≥Product numbers correct as of May 2010. These may be subject to change.
Installation procedure
Never use any other method than specified to install
Attaching the wall mount brackets
Preparation
≥ To prevent damage or scratches, lay down a soft | ≥ Keep the screws out of reach of children to |
cloth and perform the assembly on it. | prevent swallowing. |
|
|
≥Do not hold this unit in one hand to avoid injury by dropping this unit when carrying.
1 | On the rear of the unit: |
|
| Place the wall mount bracket by |
|
| aligning the holes in the wall mount | |
2 | bracket with the projecting parts A. | |
Screw the wall mount bracket firmly |
| |
| into place. |
|
Installation Instructions
≥Screw tightening torque: 80 N0cm to 120 N0cm.
≥ Repeat the steps above when installing the second wall mount bracket. | 25 |
|