Safety / Initial Use
·Do not vacuum up any toner dust!
·Do not cover the vacuum cleaner with other items! Otherwise it might be damaged by heat accumulation!
·If you are not using the vacuum cleaner, please disconnect it from the mains and roll up the power cord completely! Otherwise there is a danger of injury if it is tripped over!
·You should always use the handle when operating the vacuum cleaner. Vacuuming up fine dust results in static charges. You should therefore ensure permanent contact with the metal insert on the underside of the handle. This prevents the unpleasant effects of electrostatic discharge.
·The device should never be used without a dust bag or filter!
mCaution!
·Please avoid any damage to the power cord!
·During use the power cord should be unwound as far as the yellow marking! Otherwise there is a danger of damage from overheating!
·During use the power cord should be unrolled at least as far as the yellow marking, but not past the red marking!
·The power cord should only be removed from the socket by pulling the plug!
·Disconnect the vacuum cleaner from the mains immediately if there are any malfunctions!
·If the vacuum cleaner / power cord is damaged or broken it should only be repaired by authorised and trained specialists!
AInitial Use
AAssembly
•Press the cover release { of the dust collec- tion container and then open the cover.
•Remove the dust bag holder u together with the dust bag i and ensure that the motor protection filter o and the exhaust air filter p are assembled as shown in illustration B. Then reinsert the dust bag holder u together with the dust bag i.
•Close the cover and insert the suction hose connector } into the suction opening of the floor vacuum cleaner until it locks in place.
•Insert the tapered end of the telescopic suc- tion tube R into the connector of the floor nozzle I until it locks in place. Insert the handle Q into the telescopic suction tube R until it locks in place.
aAdjusting the Telescopic Suction Tube
• Keep the height adjuster Y held down in the direction of the arrow (see illustration D).
• Adjust the telescopic suction tube R to the desired length and lock it in place.
aUsing the Suction Nozzles
The floor nozzle I is suitable for the daily vacuuming of carpeted and hard floors. The floor nozzle I can be changed over manually - the brush strip is folded in and out.
•Operate the changeover switch O of the floor nozzle in order to fold out the brush strip. This setting allows you to vacuum up loose dust, fluff and hairs on a smooth and solid surface, e.g. floor tiles.
8 GB/IE/CY