Kompernass KH 1410 Lamellen filter, Motor protection filter, Until it can be

Lamellen filter

To take the lamellen filter out, proceed as follows:

Attention!

Before taking the filter out, remove the plug 9 from the power socket. The appliance could be inadvertantly switched on.

Afterwards allow the lamellen filter and the filter

grill to dry out (ca. 15 hours at room temperature).

Replace the lamellen filter and the filter grill only when they are both completely dry.

5.To reassemble the dust collector t proceed in the opposite sequence.

1.Remove and empty the dust collector t as described in the chapter „Emptying the dust collector“.

2.	Take off the cover	of the dust collector t
	with the lamellen filter		and the filter grill .
3.	Turn the filter grill	, until it can be removed.
4.	Turn the lamellen filter		, until it can be
	removed.

Should the lamellen filter and the filter grill be heavily soiled, rinse them both thoroughly under clean running water.

Attention!

Do not use a brush for cleaning! The lamellen filter could be damaged!

Motor protection filter

Attention!

Before taking the filter out, remove the plug 9 from the power socket.

1.Open the housing lid q.

2. Take out the motor protection filter and re- move the vacuumed in particles from the filter and the grill lying behind it.

Notice:

Should the motor protection filter be heavily soiled, rinse it thoroughly under clean running water. Afterwards allow it to dry out ( ca. 15 hours at room temperature). Replace it only when it is completely dry.

3. Replace the motor protection filter .

4.Close the housing lid q.

- 6 -