Vulcan-Hart BVD34FP30(F,L)N-1, BVP42FP52(F,L)N-1, BVD34FP50(F,L)N-1 Direct Ignition Wiring Diagram

DIRECT IGNITION WIRING DIAGRAM

SPARK IGNITOR

(OPTIONAL) WALL SWITCHÉTINCELLE ALLUMER INTERRUPTEUR MURAL

(FACULTATIVE)

(OPTIONAL) REMOTE CONTROL		CONTROL MODULE
		AUTORITÉ MODULE
RECEIVER 120V
(FACULATIVE) CONTROLE E							MAINVALVERETURN GROUND
DISTANCE DU RECEPTEUR				MAINVALVEHOT		120VACRETURN
		13	12		120VACHOT
				8	6	4	1 2
120 VAC LINE	BLACK NOIR
120 VAC RTN								BLACK NOIR
	WHITE BLANC						LIMIT SWITCH
	GREEN VERT							RED ROUGE
		LED LIGHT
	JUNCTION BOX	LED LUMIÈRE
	JONCTION BOÎTE

	Figure 24
	LED CODES
Steady ON	Normal operation, power ON to control
2 Flashes	3 unsuccessful ignition trials
3 Flashes	Main burner flame failed 4 times during a single heating cycle
4 Flashes	Interrupt power for 5 seconds to reset control
Steady Flash	Flame detected out of sequence

GAS VALVE VALVE DE GAZ

OPTIONAL REMOTE CONTROL (120V DIRECT IGNITION)

Electric (120 volt) Operated Remote Control (FREC)

1.Disconnect 3-prong power cord from receptacle.

2.Remove wire from 120 VAC hot terminal on control module.

3.Connect female terminal from receiver onto 120 VAC hot terminal on control module.

4.Connect remaining wire from remote control (male terminal) to (female terminal) on power cord removed from control module (step 2).

5.Insert electric remote control power cord plug into the junction box on the right side of fireplace.

6.Connect 3-prong plug into receptacle. See wiring diagram on page 34.

19400-3-0406 Page 23