MAINTENANCE AND SERVICE
PLEASE NOTE
It is normal for appliances fabricated of steel to give off some expansion and/or contraction noise during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.
It is not unusual for your gas fireplace to give off some odor the first time it is burned. This is due to the curing of the paint and any undetected oil from the manufacturing process.
Please ensure that your room is well ventilated - open all windows.
It is recommended that you burn your fireplace for at least six
(6)hours the first time you use it. If optional fan kit has been installed, place fan in the “OFF” position during this time.
IMPORTANT: Turn off gas before servicing appliance. It is recommended that a qualified service person perform these
•Clean Burner and Control Compartment
Keepthecontrolcompartment,logs,andburnerareassurrounding the logs clean by vacuuming or brushing at least twice a year.
Cleaning Procedure
1.Turn off pilot light at gas valve.
2.Vacuum burner compartment.
3.Ignite pilot (if applicable). (See Lighting Instructions)
4.Operate the pilot burner (if applicable). If it appears abnormal call a service person.
•Check Vent System
The appliance and venting system should be inspected before initial use and at least annually by a qualified service person. Inspect the external vent cap on a regular basis to make sure that no debris is interfering with the air flow.
Glass Cleaning (Optional Kits)
It will be necessary to clean the glass periodically. During
General Glass Information
Only glass approved for use by the manufacturer may be used for replacement. The glass replacement should be done by a licensed or qualified service person.
WARNING:
1.The use of substitute glass will void all product warranties.
2.Care must be taken to avoid breakage of glass.
3.Do not abuse the glass by striking or hitting the glass.
WARNING: Do not use abrasive cleaners on glass. Do not attempt to clean glass when glass is hot.
Page 27 |