camera assembly & mount
1.Dome Base Mounting
-Remove the protecting sheet from the rubber bottom and attach it on the base housing.
-Fix the base housing with the supplied 4pcs of screws(No.
2.Power Supply & Monitor Impedance (Power supply)
-Adaptor: AC24V / 600mA or DC12V / 800mA (AC24V / DC12V Model)
(Monitor Impedance, if available)
-Set the impedance switch to the 75
standard position unless a video equipment is connected to the monitor video out.
3.Camera Module Adjustment (Pan&Tilt Adjustment)
-Adjust the camera direction by turning the pan bracket left or right, the tilt bracket up or down, then fix the screws tight.
(View Angle Adjustment)
-For a wider view angle move the zoom lever to wide, for a narrower view angle move it to tele.
-After accurate adjustment of focal length then adjust the focus lever to near or far for the sharpest focus.
4.Decoration Ring Mounting
-Firmly fix the decoration ring into place with the screws and by using the supplied
ENG
camera assembly & mount _05