500tmOM 8/24/06 11:18 AM Page 9
Assembly Instructions
Step 1: Upright Posts Assembly
1.Straight out the main wire harness and insert it though the top of left upright post.
2.Slide the upright post onto its receptor and insert three M8 x55mm screws and washers on the side and two M8 x 15mm screws and washers on the front. Tighten these 5 screws with Allen wrench. Be careful not to pinch the main wire harness while tighten these screws.
3.Repeat procedure 2 for the Right upright post.
4.Make sure the screws are securely tightened
Step 2: Console Assembly
1.Hold the console next to the Left upright post and connect the main wire harness connectors together.
2.Insert the console U bracket into each side of upright post. Be careful not to pinch the wire harness while inserting the U bracket.
3.Insert three M8 x12mm screws and washers each on inner and outer Left upright post totally 6 screws and washers on each upright post).
4.Tighten the 6 screws securely with Allen wrench.
5.Repeat procedure 3 & 4 for Right upright post.
6.Make sure all screws are securely tightened.
500 Tm Owner’s Manual | 7 |
|
|
