Post Event
Time that an event has occurred
Camera
Sets the camera linked to the current Alarm In. The default value is set to the current Alarm In number. At least one link between Alarm In and camera has to be established. Multiple selections are possible.
The following screen will appear if the Enter(
) button is pressed by moving the cursor from the camera item.
Record the
After event occurring, sets recording time in 5 seconds ~5 minutes, and 1 hours.
If the
Alarm Detection Setup
Alarm Detection Setup
Alarm In | State | Camera |
| Duration | ||
Alarm In 1 | N.O | 1 |
| None | 10 SEC |
|
Alarm In 2 | N.O | 2 |
| None | 10 SEC |
|
Alarm In 3 | N.O | 3 |
| None | 10 SEC |
|
Alarm In 4 | N.O | 4 |
| None | 10 SEC |
|
|
|
|
| OK | Cancel | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Move/Control |
| Select | Exit | |||
State
The Alarm In type can be set to “N.O” or “N.C”.
N.O (Normally Open): Sensor remains open. But if it gets closed, an alarm is issued.
N.C (Normally Closed): Sensor remains closed. But if it gets open, an alarm is issued.
Camera 1 |
| Camera 2 |
| Camera 3 |
|
|
|
|
|
| |||
Camera 4 |
| All |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
OK Cancel
Alarm Out
Sets an
Currently, this system supports 2 Alarm Out functions and 1
The following screen will appear if the Enter(
) button is pressed by moving the cursor from the Alarm Out item.
1 2
Beep All
OK Cancel
Duration
Sets the duration for Alarm Out. The alarm sound will be maintained with the value set.
CONTINUE: The alarm output sound will be maintained until it is cancelled by pressing the ALARM button manually on the front panel.
10~300 Seconds: You can set the duration for the alarm output.
32_ menu setup