Samsung SHR-6040P, SHR-6042P manual Before start, Battery, System Shutdown, Operating Temperature

Page 4

before start

This user’s manual provides Information for using DVR such as brief introduction, part names, functions, connection to other equipment, menu setup, and the like.

You have to keep in mind the following notices:

SEC retains the copyright on this manual.

This manual cannot be copied without SEC’s prior written approval.

We are not liable for any or all losses to the product incurred by your use of non-standard product or violation of instructions mentioned in this manual.

If you want to open the case of your system for checking problems, please consult the expert from the shop where you bought the product.

You may download open source codes from the following website: http://www.samsung.com.

Before installing any external device such as external memory or HDD, please check the compatibility of the device with Samsung DVR. The list of the compatible devices with Samsung DVR can be obtained from your vendor.

WARNING

Battery

Exchanging a wrong battery in your product may cause an explosion. Therefore you must use the same type of battery as the one being used in the product. The following are the specifications of the battery you are using now.

Normal voltage: 3V

Normal capacity: 220mAh

Continuous standard load: 0.2mA

Operating temperature: -30 to +60°C

System Shutdown

CALIFORNIA USA ONLY

This Perchlorate warning applies only to primary CR (Manganese Dioxide) Lithium coin cells in the product sold or distributed ONLY in California USA.

“Perchlorate Material - special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate.”

Turning off the power while the product is in operation, or taking not permitted actions may cause damage to the hard drive or the product. Also it can cause a dysfunction to the hard disk while using the product. Please turn off the power using the Power ( /I)button on the front of your DVR. After selecting “OK” in the pop-up menu, you can pull off the power cord.

You may want to install a UPS system for safe operation in order to prevent damage caused by an unexpected power stoppage. (Any questions concerning UPS, consult your USP retailer.)

To disconnect the apparatus from the mains, the plug must be pulled out from the mains socket, therefore the mains plug shall be readily operable.

This apparatus shall always be connected to a mains socket outlet with a protective earthing connection.

Operating Temperature

The guaranteed operating temperature range of this product is 0°C to 45°C (32°F to 113 °F).

This product may not work properly if you run right after a long period of storage at a temperature below the guaranteed one.

When using the device after a long period of storage at low temperature, place the product at room temperature for a while and run it.

Especially for the built-in HDD in the product, its guaranteed temperature range is 5°C to 55°C (41°F to 113 °F). Likewise, the hard drive may not work at a temperature below the guaranteed one.

STANDARDS APPROVALS

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

The rechargeable battery incorporated in this product is not user replaceable.

For information on its replacement, please contact your service provider.

This EEE is compliant with RoHS.

Image 4 Contents
Real Time DVR Key features of your DVR WHAT’S Included with Your DVRSafety regulations Battery Operating TemperatureBefore start System ShutdownContents Search and play Appendix Introducing your real time DVR Controls on the DVRName Function This LED indicates the status of backup operation When an alarm occurs, it cancels the alarmSet up the audio On/Off function HDD, this LED repeatedly blinksTime set from the system setup Display the 4-split screensSelection Display the 9-split screensReal panel jacks Remote control Using the Numeric ButtonsPreset StopZoom MenuInstallation Checking installation environmentConnecting video, audio, and monitor To the Video in terminal with the system’s power turned offConnecting the network Connecting to Internet through Ethernet 10/100BaseTConnecting to Internet through Adsl InternetConnecting the alarm input Connecting the alarm output Connecting the RS-485 device Connecting the USBLive screen mode LiveOperating the system Live screen iconsLive screen modes Setting the audio on/off Freezing and zoomingSpot-out monitoring Event monitoringZoom function Menu setup User loginBefore use SystemTime/Date/Language Setup PasswordUser Add/Del Group AuthorityProfile System Log REC Login/Logout with the Search Mode AVI Backup Success/FailureSDB Backup Success/Failure SFX Backup Success/FailureSystem Information & Setup HDD Setup HDD END Alarm Camera HDD Format  HDD ENDScreen Setup Camera ConfigurationPTZ Device Remote Control Device Live ModeMonitoring  Event Monitoring DurationSpot Mode  Event Duration Normal Duration  CameraRecord mode Event Record SetupEvent record CIFAlarm Detection Setup  Alarm Out Post Event  StateMotion Detection Setup Video Loss Detection Setup10~300 Seconds Sets the duration for alarm output  SensitivityBackup Record scheduleNetwork IP SetupModel Size Web Viewer Port Settings Ddns Setup Network Status NTP Enable NTP SetupNTP Setup ISO Transfer Picture Setup  Smtp Server Authentication Method Authentication Method  Stmp ServerPTZ camera control mode PTZ camera controlBasic operation of pan, tilt & zoom  PANPTZ device menu setup Preset setupPreset Name Settings Camera menu setupYou can set the name of each Preset CameraRecnormal recording RecordingEvent recording Search and play Search screenSearch date & time selection Date Color DescriptionSearch channel selection & recording graph Playback Play Screen Mode Split Screen  Viewing One Scene at a Time Audio On/Off Single ScreenAppendix Net I Setup toolNet Reply message Comments Net I Live Viewer Viewing the device-related settingsTo modify the registered device Using layouts Camera Tree areaCamera Controls area Viewing areaDevice Firmware Update To update device firmwareNet I Search Viewer Query Generator areaBefore use User Administration Edit Password ResetAdd/Remove User Edit User Group AuthorityCamera Settings Video SettingsPTZ Device Settings Enable/DisableMonitoring Mode Recording ModeEvent Recording Mode Motion Detection Settings Video Loss Detection SettingsMotion Detection Zone SensitivityNetwork Settings IP ConfigurationWeb Viewer Port Setting NTP ConfigurationImage Transmission Settings Used to adjust the frame rate of individual camerasUsed to configure the picture quality of individual cameras SDB ViewerSkip Main Window of SDB ViewerSpeed Backup Voice Playback SettingZoom Digital ZoomSFX Player Execution SFX playerIntroducing Web Viewer Connecting WEB Viewer System RequirementsCPU MemoryAppendix Using Live Viewer OSD Information DisplayFull Screen Mode You can change the split mode by clicking each number iconSPLIT-SCREEN Connected DVRQuad MODE, the screen refreshes at the preset interval Changing the Live Screen ModeSaving the Live Screen on the PC Using PTZ Camera Changing the Live Screen ChannelYou can save the preset up to Using Search Viewer SPLIT-SCREENOnly Single and Quad Mode are available in Search menu Searching the Recorded Video in the Calendar Normal Mode Extension ModeSearching the Recorded Video in the Timeline Controlling PlaybackPop-up menu Names FeaturesPop-up Menu This button controls PTZ directions at PTZ mode It executes Freeze feature at Live screenIf user press Enter button, the pop-up menu will disappear VideoSpecifications SHR-6040 SHR-6042Outline drawings TroubleshootingsFAQ Color or in abnormal shape CauseConnected sensors are not working ProperlyGNU General Public License Open source license report on the productPreamble Appendix No Warranty How to Apply These Terms to Your New Programs Repair or CorrectionWe protect your rights with a two-step method You must cause the whole of the work to Appendix Executable No Warranty How to Apply These Terms to Your New LibrariesEND of Terms and Conditions FoundationOpenSSL License Loss of USE, DATA, or Profits or Business InterruptionThis Software is Provided by Eric Young ‘‘AS IS’’ Correct disposal of batteries in this product
Related manuals
Manual 96 pages 13.66 Kb Manual 96 pages 31.91 Kb Manual 96 pages 49.16 Kb Manual 96 pages 55.63 Kb Manual 96 pages 1.09 Kb