Samsung SHR-6042P Camera Settings, Name, Screen Conversion, Video Settings, Apply to All

Camera

Camera Settings

The Camera tab contains camera enable/disable and video source brightness, contrast, and color options. This tab also contains camera security options. Select a camera you wish to configure from the server list located on the right side of the screen.

2

3

1

4

5

6

7

1. Camera:

Select the camera channel you wish to configure.

2. Name:

Enter the name of the selected camera’s zone.

3. Video:

Enable/disable the selected camera.

4. Screen Conversion:

Set the screen conversion time.

5. Video Settings:

Adjust the source signal’s brightness, contrast, and color levels.

6. Apply to All:

Use this feature to apply the selected camera’s video settings to all or a designated group of cameras.

7. Reset:

Resets brightness, contrast, and color levels to their default settings.

8. Screen:

Displays the selected camera’s video feed. It’s possible to view video settings adjustments in real-time.

-Adjusting video settings does not correct improperly recorded video clips; therefore, it’s important that both the camera and the monitor are properly calibrated before recording video.

PTZ Device Settings

Your DVR system supports remote control of external devices such as a PTZ or a Speed Dome. Before using this feature, however, you will first need to connect the external device to the system via the RS485 port and configure the connected external device.

2
3
1	09
4	appendix
5

1. Camera:

Displays configured camera channels.

2. Enable/Disable:

Enables/disables the configured camera’s PTZ feature.

3. ID:

Designate an ID for the configured PTZ.

4. Protocol:

Designate the communication protocol you wish to use with the configured PTZ or Speed Dome.

5. Baud Rate:

Designate the baud rate for the configured PTZ.

Remote Control Device

This tab is used to configure the ID and baud rate for remote control devices.

appendix _55