Samsung SSA-P400T/EXP manual TCP/IP Communication Port Connection, Hub Tcp / Ip, TCP/IP Connection

Page 21

TCP/IP Communication Port Connection

1) TCP/IP Communication Conﬁguration

HUB

TCP / IP

2)TCP/IP Connection

Connect the LAN cable to the TCP/IP RJ-45 jack as shown. (applicable only to SSA-P400T / SSA-P401T)

1.Connect the RJ45 jack of the unit to the RJ45 plug, the LAN cable of the network system.

2.Set a unique communication address (COMM ADDR) for each unit

3.Install and launch the application (SAMS).

INSTALLATION AND EXTERNAL CONNECTION

English _ 21

Image 21

Contents Please visit our website Access Control PanelSafety information Safety informationImportant Safety Instructions Contents Product introduction FeaturesDoor Open Alarm and Forced Door Open Alarm Input Port Format SetupSettings Holiday SetupWHAT’S Included Main UnitCD Manual Switch Board ID SetupSwitch System after the initialization Output Relay #1 ~ Address Setup 5V for any output occurrence SwitchInput LED Indicator IndicatoradditionallySignal occurs Buzzer control settingsBoard Connector used to connect to the main boardInput port #9 Input port #8Input port #10 Input port #11Host P.C Cable SelectionTermination Resistor Connecting the Termination Resistor and DiodeBypass Diode Connection Termination Resistor in RS-485 CommunicationEARTH-GROUNDING the Communication Cables Installation and external connectionPOWER, READER, and I/O Connection Power ConnectionReader Connection Exit Button Connection Input #1, Input #3 Input ConnectionDC +12V GND Output ConnectionRS-232 Communication Port Connection Communication Line ConnectionHost PC Check the location of the communication portHost RS-422 Communication Port Connection StandaloneTX+ RX+TX+ RX+ RS-422 Communication Port Connection Multiple UnitsHUB TCP / IP TCP/IP Communication Port ConnectionTCP/IP Communication Conﬁguration TCP/IP ConnectionSwitches simultaneously Initializing the system using the Initialize switchInitialization System InitializationYou can specify between 0 and 255 for the board ID Board ID SettingTroubleshooting TroubleshootingProblem Action Problem When the system is in sync withNo communication is available Product speciﬁcations Product SpecificationsCorrect disposal of batteries in this product

Related manuals

Manual 80 pages 17.65 Kb