Samsung VR20K9000UB/EG manual ENGLISH-18, FfDo not lie down around the Powerbot that is running

Page 90

Notes and cautions

Charging

In use

 

 

Note

 

 

Note

 

 

 

 

 

 

 

 

 

 

ffIf the battery overheats during charging, it may take longer to charge.

ffWhen automatic charging is not working, do the following:

––Turn the emergency switch (on the bottom of POWERbot) off and on again.

––Unplug the docking station's power plug and then plug it back on.

––Unplug the docking station, and then check whether there is any foreign matter on the charge pins and clean POWERbot and the charge pins of the docking station with a dry cloth or rag.

––Check for any obstacles such as reflective objects, chairs, etc. near the docking station.

ffIf POWERbot is left detached from the docking station, the battery will drain naturally.

––Try to keep POWERbot being charged on the docking station. (However, turn off the emergency switch and leave the docking station unplugged when planning to leave the house for long periods of time by going on a business trip or vacation, etc.)

ffThe POWERbot may get caught on thresholds, etc. during cleaning.

––To restart operation, shut off the emergency switch, move the POWERbot to an area where it can move easily, and then turn on the power again.

ffThe POWERbot cannot completely clean areas it cannot enter, such as corners, between the wall and sofa, etc.

––Please use another cleaning tool to clean them regularly.

ffThe POWERbot cannot vacuum clumps of dirt, so some may remain on the floor after cleaning.

––Please use another cleaning tool to clean them regularly.

ffIf the battery becomes low during Auto clean mode, POWERbot will recharge and finish cleaning the remaining area after recharging. (Repeat cleaning frequency: 1 time)

ffYou cannot select and have the POWERbot execute Spot/Manual clean mode while it is charging.

ffDo not unnecessarily move the POWERbot or press buttons while it is in Auto clean mode. It assumes that cleaning is complete and starts cleaning again from the beginning.

ffClose doors before cleaning with the POWERbot. The POWERbot can enter rooms through thresholds even though the thresholds are below 5 cm.

ffTry not to use the POWERbot at areas near slides, indoor swing, pots, fireplaces, or places with flame or moisture.

–– If not, it may cause the loss of property.

ffDo not lie down around the POWERBOT that is running.

––Your hair may be caught in the power brush, resulting in physical injury.

ENGLISH-18

Page 89 Page 91
Image 90
Page 89 Page 91
Contents POWERbot DEUTSCH-02 Sicherheitsinformationen Symbole DER GEFAHREN-/WARNHINWEISEWeitere Verwendete Symbole DEUTSCH-03Allgemein DEUTSCH-04DEUTSCH-05 Warnung Reinigung und Pflege Warnung Vor der VerwendungWarnung Im Betrieb DEUTSCH-06Vorsicht Reinigung und Pflege FfVerwenden Sie den POWERbot nicht auf schwarzen BödenVorsicht Vor der Verwendung Vorsicht Im BetriebAufstellen der Dockingstation DEUTSCH-08Verwenden Sie das Zubehör DEUTSCH-09Netzkabel Batterieladegerät DEUTSCH-10 LadenÜberprüfen Sie den Ladestatus Die Nennspannung dieses Geräts Warnung beträgt 100 240 V~Laden Sie den POWERbot manuell, wenn Wenn der Ladevorgang nicht ordnungsgemäß durchgeführt wirdDEUTSCH-11 Automatikbetrieb Verwenden des POWERbotEin-/Ausschalten PunktsaugenPunktsaugen Saugbewegungen in den einzelnen ModiAutomatische Reinigung Modellreihe SR20J90U HandsaugenReinigungsmodi Verwenden der FernbedienungEin-/Ausschalten/Aufladen SaugmodiUnterseite Bezeichnung der TeileOberseite DisplayReinigen der Sensoren und der Kamera Reinigung und PflegeReinigen des Staubbehälters DEUTSCH-16Entfernen Sie die Kraftbürste Reinigen der KraftbürsteReinigen des Antriebsrads Setzen Sie die Kraftbürste wieder einHinweise und Vorsichtsmaßnahmen DEUTSCH-18DEUTSCH-19 Reinigung und PflegeInformationen zum Akku FfNach dem Reinigen von Staubbehälter und Filter mit WasserCheckliste InformationscodesDEUTSCH-20 Symptom Checkliste FehlerbehebungDEUTSCH-21 Warnhinweise zur Batterie Entfernen der BatterieDEUTSCH-22 Technische Daten Kategorie DetailinformationenDEUTSCH-23 Page Gebruiksaanwijzing NEDERLANDS-02 Veiligheidsinformatie Waarschuwingssymbolen in Deze HandleidingOverige Symbolen in Deze Handleiding NEDERLANDS-03Algemeen NEDERLANDS-04NEDERLANDS-05 Gebruik OnderhoudNEDERLANDS-06 FfHet is mogelijk dat de POWERbot tegen stoel- en LET OPNEDERLANDS-07 Installatie Van de batterijladerNEDERLANDS-08 Accessoires NEDERLANDS-09Opladen Schakel de noodstopschakelaar aan de onderzijdeNEDERLANDS-10 Laad de POWERbot handmatig op wanneer NEDERLANDS-11Automatische reiniging starten De POWERbot gebruikenHet apparaat in- en uitschakelen Lokale reiniging startenHandmatig reinigen Reinigingsmethode voor elke modusLokaal reinigen NEDERLANDS-13Zuigmodi De afstandsbediening gebruikenAan/Uit/Opladen Aanvullende functiesOnderzijde Namen van de onderdelenBovenzijde NEDERLANDS-15De sensoren en camera reinigen Reiniging en onderhoudDe stofbak reinigen Verwijder de stofbakVerwijder de zuigborstel Reinig de zuigborstel De zuigborstel reinigenHet rijwiel reinigen NEDERLANDS-17Opmerkingen en waarschuwingen NEDERLANDS-18Reiniging en onderhoud Over de batterijNEDERLANDS-19 Informatiecodes Informatiecodes ControlerenNEDERLANDS-20 Problemen oplossen Symptoom ControlerenNEDERLANDS-21 Hoe u de batterij verwijdert Leg de POWERbot neer, keer deze om en verwijder 2 schroevenWaarschuwingen over de batterij NEDERLANDS-22Gedetailleerde informatie Open Source-kennisgevingSpecificaties NEDERLANDS-23Page Manuel dutilisation Merci davoir choisi un produit SamsungNettoyage et entretien FRANÇAIS-02Nomenclature des différents composants Remarques et avertissementsDésigne une unité dalimentation amovible Symboles ATTENTION/AVERTISSEMENT UtilisésConsignes de sécurité FRANÇAIS-03Généralités FRANÇAIS-04FRANÇAIS-05 Avertissement Avantlutilisation Avertissement BranchementAvertissement Pendantutilisation FRANÇAIS-06Le POWERbot risquerait de ne pas fonctionner correctement FRANÇAIS-07Au chargeur de InstallationLa base doit toujours être branchée et allumée Raccordez la prise dalimentation à la prise muraleRemarque FRANÇAIS-09Mise en charge Il faut prévoir environ 160 minutes SérieFRANÇAIS-10 Étapes à suivre si la recharge na pas lieu Vérifiez létat dinstallation de la base lorsqueMettez le POWERbot en charge manuellement lorsque FRANÇAIS-11Mise sous/hors tension Utilisation du POWERbotDémarrage du mode Nettoyage localisé RechargeNettoyage manuel Méthode de nettoyage pour chaque modeNettoyage localisé FRANÇAIS-13Utilisation de la télécommande Écran Partie supérieurePartie inférieure FRANÇAIS-15Nettoyage des capteurs et de la caméra Nettoyage et entretienNettoyage du réservoir de poussière FRANÇAIS-16Retirez le cache de la Brosse principale Nettoyage de la brosse principaleNettoyage de la roue dentraînement Réassemblez le cache de la brosse principaleRemarques et avertissements FRANÇAIS-18FRANÇAIS-19 Nettoyage et entretienPropos de la batterie Filtre faites-le sécher à lombre avant de le réutiliserCodes dinformation Liste de vérificationFRANÇAIS-20 Dépannage Symptôme Liste de vérificationFRANÇAIS-21 Allongez et retournez le POWERbot puis retirez 2 vis Comment retirer la batterieFRANÇAIS-22 Élément Informations détaillées Annonce de logiciel open sourceSpécifications FRANÇAIS-23Page Thank you for purchasing a Samsung product Cleaning and maintaining ENGLISH-02Name of each part Indicates a detachable supply unit Safety informationInformation ENGLISH-03General ENGLISH-04ENGLISH-05 ENGLISH-06 FfDo not use POWERbot near combustible materialsFfAlways keep the cliff sensor clean for your safety FfPlease prevent any risk of electric shock or fireFfDo not use POWERbot on black colored floors FfDo not use POWERbot on tables or other high surfacesENGLISH-07 Power indicator lamp Red will turn on ENGLISH-08About 0.5 m Accessories ENGLISH-09Charging ENGLISH-10Steps to take if recharging not occuring Check the installation status of the docking station whenManually charge the POWERbot when ENGLISH-11Starting Auto clean mode Using POWERbotTurning the power on/off Starting Spot clean modeManual clean Cleaning method for each modesAuto clean Spot clean SR20J90U Series ENGLISH-13Using the remote control Bottom Name of each partTop Display panelCleaning the sensors and the camera Cleaning and maintainingCleaning the dustbin ENGLISH-16Remove the Power Clean the Power brush Brush cover Cleaning the Power brushCleaning the Driving wheel Reassemble the Power Brush Brush coverFfDo not lie down around the Powerbot that is running ENGLISH-18If not, it may cause the loss of property ENGLISH-19 Cleaning and maintenanceAbout the battery FfIf you washed the dustbin and filter with waterInformation codes Checklist Information codesENGLISH-20 Troubleshooting Symptom ChecklistENGLISH-21 How to remove the battery ENGLISH-22Detail information SpecificationsOpen Source Announcement ENGLISH-23DJ68-00740G-02
Related manuals
Manual 312 pages 12.66 Kb Manual 26 pages 40.25 Kb Manual 26 pages 31.35 Kb Manual 26 pages 32.57 Kb Manual 48 pages 23.42 Kb

VR20J9020UR/EG, VR20K9000UB/GE, VR20K9000UB/EG, VR20J9020UG/EG, VR20K9000UB/ET specifications

The Samsung VR20K9000UB/EG and VR20K9000UB/GE robotic vacuum cleaners represent a significant advancement in home cleaning technology. These innovative devices are designed to effortlessly maintain cleanliness in your living space while incorporating state-of-the-art features to enhance user experience.

One of the standout features of the Samsung VR20K9000 series is its powerful Samsung Digital Inverter Motor, which delivers strong suction while maintaining energy efficiency. This ensures thorough cleaning across various surfaces, from carpets to hardwood floors, picking up dirt, debris, and pet hair with ease. The motor is also designed for longevity, promising users reliability and performance over time.

Equipped with the Smart Suitcase Design, the VR20K9000UB models are engineered for optimal movement in tight spaces. Their unique shape enables better navigation around furniture, allowing them to clean areas that traditional vacuum cleaners might struggle to reach. Paired with an enhanced sensor system, these vacuums can detect obstacles and adjust their cleaning path accordingly.

Another key technology featured in these models is the "Cyclone Force" multi-cyclone system, which helps to separate dirt from the air, ensuring consistent suction power without losing performance over time. This cyclonic technology also minimizes maintenance, as the dust canister design allows for easy emptying and cleaning.

The automatic charging feature is a significant convenience, enabling the vacuum to return to its dock when the battery is running low. This ensures that cleaning sessions are uninterrupted and that the unit is always ready for the next use. Additionally, the VR20K9000UB/EG and GE models are equipped with a range of customizable cleaning modes, enabling users to select the right setting for their specific cleaning needs.

Smart connectivity sets these vacuums apart from many competitors. Users can control the device remotely via a smartphone app, allowing for scheduling and real-time monitoring of cleaning sessions. This integration with smart home ecosystems enhances the overall user experience and adds a level of convenience that is hard to ignore.

Built with a sleek aesthetic, the Samsung VR20K9000UB/EG and VR20K9000UB/GE not only perform well but also add a touch of modern elegance to your home. Their combination of powerful suction, advanced technology, and smart features make them an exceptional choice for anyone looking to simplify their cleaning routine. With these robotic vacuums, Samsung continues to lead the way in innovative home cleaning solutions, making life easier for users everywhere.
Top Page Image Contents