Samsung UE55ES7000QXZT, UE40ES7000QXZT manual Storage and Maintenance, Securing the TV to the Wall

Page 21

Storage and Maintenance

If you attached some stickers on the TV screen, it remains some debris after removing the sticker. Please clean it to watch TV.

English

Do not spray water directly onto the product. Any liquid that goes into the product may cause a failure, fi re, or electric shock.

Clean the product with a soft cloth dapped in a small amount of water. Do not use a fl ammable liquid (e.g. benzene, thinners) or a cleaning agent.

Securing the TV to the Wall

Caution: Pulling, pushing, or climbing on the TV may cause the TV to fall. In particular, ensure your children do not hang over or destabilize the TV. Doing so may cause the TV to tip over, causing serious injuries or death. Follow all safety precautions provided in the included Safety Flyer with your TV. For added stability and safety, you can purchase and install the anti fall device as described below.

To Avoid the TV from Falling

1.Put the screws into the clamps and fi rmly fasten them onto the wall. Confi rm that the screws have

been fi rmly installed onto the wall.

You may need additional material such as an anchor depending on the type of wall.

Since the necessary clamps, screws, and string are not supplied, please purchase these

additionally.

2. Remove the screws from the back centre of the TV, put the screws into the clamps, and then fasten the screws onto the TV again.

Screws may not be supplied with the product. In this case, please purchase the screws of the following specifications.

Screw Specifications

• For a 19 ~ 27 inch: M4

• For a 32 ~ 75 inch: M8

3.Connect the clamps fi xed onto the TV and the clamps fi xed onto the wall with a strong cable and

then tie the string tightly.

NOTE

Install the TV near to the wall so that it does not fall backwards.

It is safe to connect the string so that the clamps fi xed on the wall are equal to or lower than the clamps fi xed on the TV.

Untie the string before moving the TV.

4.Verify all connections are properly secured. Periodically check connections for any sign of fatigue for failure. If you have any doubt about the security of your connections, contact a professional installer.

English - 21

Image 21
Contents 0180 5 7267864* *0,14 €/Min. aus dem dt. Festnetz, aus Samsung 80111 726 7864 only from land lineBN68-04060G-04 Still image warning Digital TV notice10 cm Installation with a wall-mount Installation with a stand 10 cmProviding Proper Ventilation for Your TV Other WarningsAccessories List of FeaturesScart Adapter Holder-Wire stand Holder Ring x Wireless KeyboardUsing the TVs Controller Panel Key Connecting to an AerialFollow these instructions facing the front of your TV Smart Touch Control Installing batteries Battery size AASmart Touch Control Guide Returnr Returns to the previous menuInitial Pairing Using the Touch PadIR receiver 30cm ~ 4m Smart Touch Control Connecting To Select an item Press the Touch PadIR Blaster Connecting Pairing complete IR receiver 30cm ~ 4m Device Indicator LEDIR Blaster Guide Push it backWhen you turn the IR Blaster on, the LED blinks Using the Search for recommended model codeSelect Download to download the recommended model code Anynet+ HDMI-CEC functionViewing the Remote Control Setup Initial Setup Select Yes to start the Universal Remote Setup Additional option to setup the pin numberUniversal Remote Control section in the manual You watch your TVConnections Source Changing the Input SourceSmart Interaction Motion control Voice ControlFace recognition TV Rear Evolution Kit Slot Kit Sold SeparatelyNetwork Connection Wired Network ConnectionModem Cable LAN Cable LAN Port on the Wall How to view the e-Manual Preparing before installing Wall-Mount Installing the Wall MountTo install a wall-mount, use the Holder-Ring InchesSecuring the TV to the Wall Storage and MaintenanceTroubleshooting Display ResolutionIssues Solutions and Explanations Smart Control SpecificationsLicence IR BlasterAvvertenza per la visualizzazione di immagini fisse Avviso relativo alla trasmissione TV digitaleGarantire unadeguata ventilazione al televisore Altre avvertenzePuò essere richiesto un rimborso se Tastiera wireless AccessoriElenco delle funzioni disponibili Manuale dellutenteCollegamento allantenna Uso del Controller TV tasto pannelloQuesto LED indica il dispositivo attivo Guida alluso dello Smart Touch ControlUtilizzare questi tasti in base alle istruzioni a schermo Cambia i canali Touch PadAbbinamento iniziale Uso del Touch PadPer selezionare una voce Premere il Touch Pad Ricevitore IR 30cm ~ 4m Smart Touch Control CollegamentoAfferrare il portabatterie da entrambi i lati ed estrarlo Guida alluso dellIR BlasterInserire nuovamente in sede il portabatterie Ricevitore IR 30cm ~ 4mQuando si accende lIR Blaster, il LED lampeggia Pairing sul fondo dellIR BlasterVista del telecomando Impostazione Impostazione iniziale Base alla nazione Selezionare il PaeseDel televisore Contr. vocale e delCollegamenti Sorgente Modifica della sorgente di ingressoInterazione Smart Contr. del movimento Controllo vocaleSmart TV accendi Dimens. barra comando vocale Sensibilità vocRiconoscimento facciale Alloggiamento Evolution Kit venduto separatamente Porta LAN a parete Connessione di retePorta modem a parete Cavo modem Cavo LAN Porta LAN a pareteCome visualizzare le-Manual Pollici Spec. Vesa a * B Vite standard Quantità Installazione del supporto a pareteConservazione e manutenzione Fissaggio del televisore alla pareteSlegare il cavo prima di spostare il televisore Risoluzione dei problemi Problemi Soluzioni e spiegazioniRisoluzione del display Smart Touch Control SpecificheLicenza Diagrammi a blocchi Warnung bei Standbildern Hinweis zu DigitalfernsehenVerwaltungskosten werden abgerechnet, wenn Sonstige WarnhinweiseZubehör Liste der FunktionenSmart HUB Der Gateway zu allen integrierten Inhalten Garantiekarte nicht überall verfügbar / SicherheitshinweiseAnschließen an eine Antenne Verwenden des TV-Controllers TastenEinlegen von Batterien Batteriegröße AA Anleitung für die Smart Touch ControlLED zur Anzeige des aktiven Geräts Wechseln des Senders TouchpadAnfängliches Pairing Verwenden des TouchpadsZum Auswählen eines Elements Tippen Sie auf das Touchpad Anleitung für den IR Blaster Pairing-TasteVerwenden der Funktion Ton aus Infrarotempfänger 30cm ~ 4mPENOwiederholen Sie das Verfahren ab Schritt Suchen nach dem empfohlenen ModellcodeFernbedienung Einstellung Anfangseinstellung Menüsprache Auswählen der Sprache Modusauswahl AuswählenDies kann je nach Netzwerkstatus einige Zeit dauern Je nach Land Das Land wählenMöchten Und Regionsauswahl Je nach LandMaximaler Durchmesser 14 mm AnschlüsseQuelle Ändern der EingangsquelleSMART-Interaktion Bewegungssteuerung SprachsteuerungGesichtserkennung Evolution Kit-Steckplatz Kit ist separat erhältlich Setzen Sie die „CI- oder „CI+-Karte einRückseite des Fernsehgeräts LAN-Kabel NetzwerkverbindungModemanschluss an der Wand Modemkabel LAN-Kabel LAN-Anschluss an der WandAnzeigen des e-Manual Vorbereitung zum Anbringen der Wandhalterung Anbringen der WandhalterungProduktfamilie Zoll MengeBefestigen des Fernsehgeräts an der Wand Lagerung und WartungEinem Stromschlag führen So verhindern Sie, dass das Fernsehgerät herunterfälltProbleme Lösungen und Erklärungen FehlerbehebungAnzeigeauflösung Technische Daten Lizenz IR-Blaster
Related manuals
Manual 929 pages 5.07 Kb Manual 46 pages 49.5 Kb Manual 1 pages 60.7 Kb Manual 867 pages 42.16 Kb