Samsung SDM-160N manual When desiring to see automatic sequential conversion screen

Page 21

Digital Multiplexer

When desiring to see automatic sequential conversion screen

The automatic sequential conversion mode operates in the LIVE screen status and consists of the fol- lowing 2 cases:

The FULL screen is converted if pressing the “SEQUENCE” button in the FULL screen status. The screen on the bottom right side is converted if pressing the “SEQUENCE” button in the 4, 9-division screen status. The LED of the “SEQUENCE” button turns on for both cases.

The conversion time in the automatic sequential conversion mode is set in the “SEQUENCE..” of the “2. MON OUT SET” in case of the PRPGRAM mode for the FULL screen and the time to set up is 00sec ~ 30sec. The screen set to 00sec is skipped. The screen on the right bottom is switched in the interval of a second for the 4, 9-division screen.

➢Method to release

-Press the “SEQUENCE” button once again. In this case the LED turns off. And then it stops on the screen currently seen.

➢The “SEQUENCE” button does not operate in the following cases:

-In replay mode or TRIPLEX mode

-In the division screen mode other than 4, 9-division screen

-In setting of program mode

-In displaying ALARM/LOSS LIST on screen

-During ZOOM operation

-During ALARM operation

ENGLISH

4-3

Image 21

Contents Digitalmultiplexer Digital Multiplexer Graphic Symbol ExplanationIii Contents Appendix B Checking Points in Trouble Introduction IntroductionName of parts and Function Move → With RS-232C cable, Remote Control can be done Indicates terminal for connecting to VCR Input/OutputWith RS-485 cable, Remote Control can be done Connects to Power CordPhysical & Environmental Preparing for the InstallationPrecautions when Installing Page Unpacking Connecting to normal VCR and Monitor Connecting to Other DevicesConnecting to S-VHS VCR and S-VHS Monitor OUT terminal on the VCRConnecting to Time Lapse VCR Connecting to Alarm Sensor Ascii Remote Control by connecting to PCCH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 Ascii AautoMonitor OUT Control Remote Control using SSC-1000RS-485MON button → Address + 1 input → Enter Spot OUT ControlWhen desiring to see in the Triplex screen When desiring to see in the live screen/replay screenBasic Method to use Initial operationWhen desiring to see in the division screen When desiring to see in the Full screenWhen desiring to see automatic sequential conversion screen When desiring to see the stop screen When desiring to see in the zoom screenFull Mode When desiring to see in the PIP screen When desiring to see in the record screenWhen desiring to see output of VCR as it is Record setting of each camera Setting of Program MenuREC OUT SET Type TLV Duty SET Reservation OFFREC Duty SET CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 REC Reservation Start TimeEND Time Sequence Loss Detect Loss Info Alarm Info Motion Info Setting of display modeALL PB Display ALL Spot OUT Cvbs PIP SizeSequence Alarm S/W TimeYou can set of each channel Setting of title by channelBlinking character moves if pressing →, → button Enter button at a position desired to set titleTitle SET IjklmnopqrstuvwxyzDATE/TIME SET Display Type Setting of motion Setting of alarmXxxxxxxxxxx Password Change System settingPassword Check OFF Alarm Buzzer Loss Buzzer Summer Time Baud RatePassword Change Password Check NEW Password Confirm Enter the current password in orderIs displayed on screen when entering password Normal record mode Time Lapse record modeRecording Alarm weight value record Weight value REC Duty recordReservation record REC DutyAlarm release Alarm occurrence conditionsAlarm record Alarm signal standardAlarm/Loss list reference Operation in video lossOperation in motion detection Appendix a Specifications Outside Drawing Appendix B Checking points in trouble Ensure power cord is properly inserted