Samsung AR10NVFSCURNSV manual Indoor Unit Installation

Indoor Unit Installation

Installation

Step 2.1 Connecting the power and communication cables (assembly cable)

Control box

Before
connecting
Correct	Upside down	Damaged	Non-circular
After
connecting
Correct	Correct	Upside down	Non-fitted
(Front view)	(Side view)
<Circular terminal>

**09/12/18*********24*******

N(1) 1 2 1(L)2(N) F1 F2

Fasten the screws for the wire holders.

Model	**09*******	**12/18*******
Power cable	3G x 1.0 mm²,	3G x 1.5 mm²,
(Indoor unit)	H05VV-F	H05VV-F
Indoor-to-Outdoor	4G x 1.5 mm²,	4G x 1.5 mm²,
power cable	H07RN-F	H07RN-F
Type GL	20A	25A
Model	**24*******
Power cable	3G X 2.5 mm²,
(Outdoor unit)	H07RN-F
Outdoor-to-indoor	3G X 1.0 mm²,
power cable	H07RN-F
Communication	2 X 0.75 mm²,
cable	H05RN-F
Type GL	25A

•When performing electrical and earthing works, be sure to comply with the 'technical standards of electrical installations' and the 'wiring regulations' in the local regulations.

•Tighten the terminal block screw to 1.2-1.8 N•m (1.2-1.8 kgf•cm).

NOTE

•Each wire is labelled with the corresponding terminal number.

•Use shield cable (Category 5; less than 50pF/m) for noisy environmental site.

•Power supply cords of parts of appliances for outdoor use shall not be lighter than polychloroprene sheathed flexible cord. (Code designation IEC: 60245 IEC 66/CENELEC: H07RN-F, IEC: 60245 IEC 57/CENELEC: H05RN-F, IEC: 60227 IEC 53/CENELEC: H05VV-F)

•Power & Communication cable shall not exceed

30m.

CAUTION

•For the terminal block wiring, use a wire with a ring terminal socket only. Regular wires without a ring terminal socket may become a hazard due to overheating of the electrical contact during installation.

•If you need to extend the pipe, be sure to extend the cable, too.

	(Unit : m)
Model	Cable (Maximum)
**09*******
**12*******	20
**18*******
**24*******	30

•Do not connect two or more different cables to extend the length. This connection may cause fire.

•Each circular terminal must match the size of its corresponding screw in the terminal block.

•After connecting the cables, make sure that terminal numbers on the indoor and outdoor units match.

•Ensure that power and communication cables are separated, they must not be in the same cable.

WARNING

•Connect the wires firmly so that wires cannot be pulled out easily. (If they are loose, it could cause burn-out of the wires.)

30English