reader mode setup
-You can specify the operation mode for the device.
-Once a mode is specified, it will not switch until you perform the initialization.
-You must keep the Master Card in safe for later use as it is required for your change to the device settings.
-If progression is halted for more than one minute during any of the following processes, the operation mode of the reader will return to the previous state.
READER MODE SETUP (RF ONLY)
No Master Card or Master PIN is ever registered.
If you remember the Master Card or the Master PIN was registered, initialize the product and try again.
1.When you turn on the product, all of the 3 LED indicators will flash with a beep.
•No flashing of the 3 indicators denotes that the reader mode is already specified.
2. Press Button 0 and Button 1 in sequence and press ENT . When the mode is specified, only the green LED indicator flashes.
3.Present a card that you want to register as the Master Card to the device. When the Master Card is registered, only the red LED indicator flashes.
4.Present cards to register with the device one after another, and the device will register them with a beep. If you don’t want to register the cards right now, simply jump to Step 5 above without through Step 4 above.
5.Present the registered Master Card to the product once again.
6.The device enters Standby mode with only the orange LED indicator flashing.
X Y Z
[\ ] ^ _ `
lzj W lu{
i
zzhTzYWWW
X | Y | Z | Î | X | Y | Z | Î | X | Y | Z | Î |
[ |
| ] | [ | \ | ] | [ | \ | ] | |||
|
|
|
| ^ | _ | ` |
| ^ | _ | ` |
|
tGj | W | lu{ |
| lzj | W | lu{ |
| lzj | W | lu{ |
|
lzj |
|
|
|
|
| ||||||
i |
|
|
| i |
|
|
| i |
|
|
|
|
| zzhTzYWWW |
|
|
| zzhTzYWWW |
|
|
| zzhTzYWWW |
|
tGj
X Y Z
[\ ] ^ _ `
lzj W lu{
i
zzhTzYWWW
18_ reader mode setup