Desa CSG3930NR, CSG3930PR Installing Logs, Installing Log #4 Model CSG3924NR Shown

Page 15

INSTALLATION

Installing Logs

15

INSTALLATION

Continued

INSTALLING LOGS

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically there- after, check to ensure that no yellow flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs according to the log installation instructions in this manual. Yellow flames contacting logs will create soot.

Log #3

Log #2

Log #1

It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater. Before installing logs, make sure log alignment screws are in place and straight.

Models CSG3924NT, CSG3924PT, CSG3924NR,

CSG3924PR, CTB3924NT, CTB3924PT, CTB3924NR

CTB3924PR, CSG3930NR, and CSG3930PR,

1.Place log #1 (ember bed) onto base. Position log over alignment screws to left of front burner and behind middle burner. Ember bed will sit on top of front and middle burners (see Figure 19).

2.Place log #2 to the right of log #1. Log #2 will wrap around right end of rear burner and sit on log alignment screw (see Figure 20).

3.Place log #3 on left side of base and onto alignment screw to right of rear burner (see Figure 20). Log #3 will wrap around left end of rear burner.

4.Place log #4 onto two alignment screws to the rear of base (see Figure 21).

5.Place back of log #5 on notch in log #4 (as shown in Figure 22), across back part of log #1 and onto pin on log #2 (see Figures 20 and 22).

6.Place log #6 onto two pins on log #1 (ember bed) and rest back of log #6 on back log #4 (see Figure 22).

Figure 20 - Installing Log #2 (Right) and Log #3 (Left) (Model CSG3924NR Shown)

Log #4

Log #3

Log #1

Log #2

Figure 21 - Installing Log #4 (Model CSG3924NR Shown)

Log #6

Log #5

Log #5 will seat in

Log #3

this location.

 

Log #1

 

Log #4

Log #1

Log #2

Figure 22 - Installing Log #5 (Right) and Log #6 (Left) (Model CSG3924NR Shown)

Figure 19 - Installing Log #1 (Ember Bed) (Model CSG3924NR Shown)

For morevisit www..com

110021-01G

Image 15
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualSafety Information Table of ContentsSafety Information Unpacking Optional Remote Control AccessoriesProduct Identification Local CodesAIR for Combustion and Ventilation Product FeaturesDetermining if You Have a Confined or Unconfined Space Determining FRESH-AIR Flow for Heater LocationVentilation AIR Ventilation Air From Inside BuildingVentilation Air From Outdoors Installation Installation and Clearances for VENT-FREE OperationCheck GAS Type See Between 8 Minimum Noncombustible Material ClearancesDetermining Minimum Mantel Clearance Determining Minimum Mantel Clearance When Using a HoodMantel Clearances Floor ClearancesRemote-Ready Models Only Installing Damper Clamp Accessory for Vented OperationInstalling Heater Base Assembly Installation Items NeededAttaching Base Assembly to Fireplace Floor 30 Model Shown Connecting to GAS SupplyExternal Regulator With Vent Pointing Down Pressure Testing gas Supply Piping system Pressure Testing Heater Gas ConnectionsChecking GAS Connections Installing Log #4 Model CSG3924NR Shown Installing LogsInstalling Log #2 Right and Log #3 Left Model VRL30NR Shown Lighting Instructions Attaching Grate to Base AssemblyOperating Heater Adding Lava RockShutting Off Heater Manual Lighting ProcedureTo Turn OFF GAS To Appliance Thermostat Control OperationREMOTE-READY Models For Your Safety Read Before Lighting Control Knobs and Ignitor Button Locations Shown Optional HAND-HELD Remote OperationON/OFF Series Models Ghrcb and Cghrcb Manual ModeAuto Thermostatic Mode Safety FeaturesInspecting Burners Pilot Flame PatternBurner Flame Patterns Cleaning Maintenance Cleaning Burner Injector Holders and Pilot AIR Inlet HolesLogs Observed Problem Possible Cause Remedy TroubleshootingRefer to Air for Combustion and Venti Gas leak. See Warning statement Important Do not crimp capillary Optional Positioning of Thermostat Sensing BulbSpecifications Wiring DiagramREMOTE-READY Models only Illustrated Parts Breakdown Illustrated Parts Breakdown THERMOSTAT-CONTROLLED Models Parts List2325 1026 Natural Gas Models Only REMOTE-READY Models Accessories Owners Registration Form Postage Required Parts Under Warranty Replacement PartsService Hints Technical ServiceNot a UPC