SAFETY INFORMATION
Continued
15.Install the heater such that it is not directly exposed to water spray, rain, dripping water and/or wind.
16.Operate only on a stable, level surface.
17.Due to the high surface and exhaust tempera- tures, adults and children must observe clear- ances to avoid burns or clothing ignition.
18.Do not move, handle or service while hot or burning. Do not attach or remove a hot or operating heater from the propane/LP tank.
19.Before each use, check heater for leaks. Never use an open flame to check for leaks. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks.
20.Keep all connections and fittings clean. Make sure propane/LP tank valve is clean. Check "O" ring on heater inlet fuel valve connector for damage before each use. Replace if worn or damaged.
21.Use only in accordance with local codes or, in the absence of local codes, with the Standard for the Storage and Handling of Liquefied Pe- troleum Gases ANSI/NFPA 58 and CSA B149.1, Natural Gas and Propane Installation Code.
ASSEMBLY
INSTRUCTIONS
30,000 BTU MODELS ONLY
1.Inspect the heater components for possible shipping damage. If any is found, immediately notify the dealer. Check to make sure that all components are included with your heater (see pages 8 and 9).
2.Insert the piezo ignitor into the bracket on the burner support bracket as shown in Figure 1. Tighten the piezo mounting nut. Do not over tighten the nut.
3.Connect the burner hoses together as shown in Figure 2. Wrench tighten to insure leak tight connection.
4.Mount the burner assembly onto the support arm using the burner head mounting brackets and brass screws as shown in Figure 3. Place side of bracket into the slot on support arm. Se- cure with screw. Make certain that the air holes on the sides of the burner tube are not blocked. Securely tighten the burners into place.
5.Attach the electrode wires to the piezo ignitor as shown in Figure 4.
Piezo Ignitor
Piezo
Mounting
Nut
Burner
Support
Bracket
Figure 1 - Installing Piezo Ignitor
Figure 2 - Attaching Burner Hoses to
Regulator
Burner Head
Assembly
Slot | Support | |
Arm | ||
|
| Air Hole | |
Brass Screw | Burner Head | |
Mounting Bracket | ||
|
Figure 3 - Attaching Burner Head
Assembly to Support Arm
Piezo Ignitor
Electrode Wires
Figure 4 - Attaching Electrode Wires to Piezo Ignitor
4 | www.desatech.com |